Search results

Cheers newboy. Thats my job for tomorrow. Coops

Hi Over the last couple of days I have noticed that the Hot Tap on the basin in the downstairs loo has become increasing hard to open. The amount of turns seems to be decreasing - cannot seem to open the tap on full, worried just incase I break the tap. The flow is just about ok...

RF Lighting, Does this mean, that based on the same rules of adding a spur to a ring via a socket you should only do it once - unless using an FCU. Does the same apply to the fact that I am planning to add the cable direct to the 32A MCB in the consumer unit and that this should only be done...

Looking to add 2x double sockets

PrenticeBoyofDerry: the protection is in the form of a MCB 32A. The cable I am using is 2.5mm T&E. I hope this helps in clarifying. Let me know if your answer changes based on the new information. Cheers Coops

Thank you for your replies. I have a small roof loft over the garage ( that sticks out a little from the front of the house - part integral) and I have access to the loft from the small roof loft and in turn to the CU. Most of the house wiring goes through the small loft to the CU below. I...

You can do it yourself, I did ours, I put the alarm into engineer mode, not sure if you can change the battery with your normal code. Ordered new battery off internet. Hope this helps Chris

Hi I was wondering if it is okay to add a separate 2.5mm cable to the MCB, on the fuse that carries the "upstairs sockets - this carries the ring for upstairs sockets" and take the single 2.5mm direct to a FCU (13amp) to power a two twin sockets that would have a load less than 13amps...

Oh, forgot to say thank you for your speedy reply Thank you Coops

Hi Gordangas Is it possible to change Thermostat value without draining the system / radiator? Coops

Hi I have noticed that the radiator in one of the bedrooms is always hot / on even when the thermostat on the radiator is set to 0. There seems to be no adjustment on this radiator at all. Now, I cannot remember if I am correct here, but I believe that it did change temperature when I...

Hi I have a hinge on my uPVC double glazed window that needs replacing as there is a bit too much play that stops the window from closing. Have to give the window a tap to push the inner part of the hinge into place for the window to close. I have been looking on the internet tonight for a...

Please note the hinge that need replacing is the one closest the wall - not the friction hinge at the centre bottom of the picture