Search results

I am in a bit of a state as were to go setting the door back up The door has a slightly wider gap at the hinge side from halfway down the door Do i have to remove the cover as shown from the inside to get at a adjuster or is it all done by the allen screws that i believe are under the caps ...

middle door hinge

door hinges

The numbers and letters are rubbing off on the front cover ,not through wear but yuo can remove them to easily Anybody had the same issue Anyone had the same problem thanks nobby

I have a fire surround to paint in white Using good quality acrylic wood primeras a first coat The surround was previously Polyurethane varniished I have machine sanded back to wood but have three knots that that i am worried about They a re not bleeding or sticky any suggestions thanks

that will do for me MKM Just up the road thanks

i have a flat felt kitchen roof that has some adhesive peeling at the back were it meets the wall about 2 inches up I also have one or two 6inch cracks in the felt at the front of the roof just before it bends over to the gutter What i need is some black patching adhesive that can take a...

I have a gap above new door filled with expanding foam to make up void and insulate i now want stick a piece of 90mm profiled plastic over it to finish off Can i use no nails type adhesive I have 2 full tubes that are not solvent based form a trade counter i also have quite a few tubes of...

took a bit of advise of you all really "shimmed" the joint out to get a tight fit then used some gorilla glue Still early days but it appears a tight fit We shall see thanks

I have tried various pva and epoxy glues and havnt had much success with loose dining room chairs (wood) Any advise on what the trade would use I have took apart and really cleaned up the joints and have a clamp Just the right glue please thanks

big help that chaps I reckon i know what im looking for now

This is the inner seal from a 30 year old UPVC window do you reckon it is still available i cant seem to match up on auction site http://s1104.photobucket.com/user/charleswestover/media/7894eb67-dada-46d0-ba6f-e92460febcda.jpg.html?state=copy&sp=false

thanks a lot give that a go in the morning and get back if i have a problem

Could anyone sort me out with the wiring on this outside light AS you can see the mains wire is to the left and the pir wires to the bottom thanks http://s1104.photobucket.com/user/charleswestover/media/photo.jpg.html?sort=3&o=0

thanks well i have had it boiling and then soaking in water thaen left out over a couple of nights and it looks fine I just wondered if a coat of something might be a good idea i will be staining it to a mid oak colour regards

I have the idea of using some marine ply I have for a outdoor folding table for summer. it is 19mm thick in 8 inch strips how do I know if it is good quality for the job and what should I seal it with I was going to rout the edges to give a smooth finish and wondered about water ingress

I have sorted the valves out with your help suggestions of closing the valve to half a turn upstairs and lowering TRVdown to two really helped i have even heating around the house after balancing them this way thanks

up and running now needed a diverter valve in the end thanks everyone for your help i have learnt a lot

i get your drift Its not my house its my daughters so i wont be able to see what they are now I do remember them being number 1 and up to 4 or 5 also a snowflake emblem at the lower end if that is of help I will get back tomorrow thanks

Thanks i see , What if i wanted to turn a radiator off altogether then or isnt there a need to if i do as you suggest