Search results

is there a any way of getting into these taps to clean out the valve that shuts of/on the shower.We have a prostate probem with it The flow to the hot and cold is good but coming out of the flexi it is poor cant even get a shower Oh and the valve is tuned on by the slider on the shower mixer...

a good few years ago the engineer that fitted my back boiler put in a air vent that is positoned to the back and one side of my chimney breast on the floor it just has 6 large holes drilled in the floorboards and a plastic air vent over the top. i want to change my carpet and was wondering if...

wondered what was the best product for double glazing i need to reseal around the plastics inside an i do get a tad of mildew i just dont like getting ripped of in the big sheds many thanks pat

i have the idea of buying some 9 vertical blinds of the internet and installing myself. There prices are much more competitive than to have them done locally i wondered if you have any experiences you could give me , i am able enough in most DIY . i just like to ask them who know...

thanks will try that

i have just repaired a rad valve and had to empty the rad and flush it .All back together now but i have bled it and i cant shift air in the top corner furthest away from the bleed valve . It is the highest rad in the bedroom .Has anyone any other suggestions thanks

stopped the leaks but cant get the repair kit . could you point me to a supplier thanks

i have a kitchen floor covered in ceramic tiles i would like to put laminate floor tiles down on top The reason is that the original tiling has been fixed straight to the wooden floor , i believe it to be the water resitant chip board . It has served well with just a few minor cracks I dont...

so i turn off pump etc. What happens if i undo gland nut to pack with PTFE tape wont i get water coming out, dont get that bit. pat

any help on this one please

it doesnt leak when the plassy top on the valve is tightened shut v.It starts to leak when you start and turn the valve on coming from i believe the large nut . down theinside of plassy cover and onto the pipe. it isnt from the chrome doomed cover that covers the isolating screw...

it has YORKSHIRE IMPERIAL on the top and is 30 years old THANKS

hi i remember a plumber telling me you could stop the weep coming from the top of the valve when you turn the rad on . Has onyone any advise for me. Ther e are two to do and i was hoping to remedy it without draining the system It is a microbore twin inlet valve (inlet and outlet at the same...

hi i have a bosch washer 2 years old that vibrates to a point of making a loud knocking noise on full 1000 spin it appears to be hit the sides of something . I have noticed the damper legs on them are a bit light weight i complained to bosch about it but i was out of guarentee , jus,t and...

thanks SIMOND so to sum up i can run a microbore system on a combi using the crap remover you suggest and dont need to have TRV . Sorry to be a bit finnicky .just want to be prepaired

i also have twin entry ( maxitwin valves fitted ) would they be alright . i have no TRV,s fitted

Hi i have a 8mm microbore central heating system that is run by a very reliable potterton 25 years back boiler, However it is not that economical and i wonder if it will last Would it be possible to install a condenser/combi to run with the microbore as the access to pipes would be a right...