Search results

Good morning I'm still using a baxi 105e with a mechanical clock . I'm thinking of replacing it with a wireless room thermostat ( it looks a easy job correct me if I'm wrong). My question is after I fit the wireless stat will the boiler just keep the burners on until the room reaches...

Dodgy bearing ? . Maybe you over tightened it when you installed it and it's vibrating

That looks ok as it's not touching the micro switch . It will probably drop further when the system is cold

Don't forget silicon grease on the pump rubber washer and take the screw out of the automatic air vent

The return valve filter is on the right hand side pipe with a blanking nut on it . There's a video on YouTube telling you how to remove it . Considering you'll need to drain the boiler down to clean the filter might be worth looking at the pump

Just change the thermistor it costs £3 delivered from eBay. If I can remember right it's just a 13mm spanner to screw it off and replace it . If that doesn't work phone your gasman

Speedometer cable?

Thanks everyone for your help it worked (so far anyway) . I think it was leaking from both ends the Bush nut looks like it's been leaking and the tiny o-ring on the other part disintegrated when I pulled it out . Thanks again

Hi sorry to be a pain but I've just received another bush nut from ebay and its the same as the original part that was missing the white plastic insides!. Could I be missing something

Thanks I'll contact the people I purchased it from

does this bush nut look incomplete? Shouldn't it have a white plastic bit in the middle and not just a hole?

Just a quick update. When I got up this morning there was a drip of water on the valve . I had a sniff and it smells chemically, it's certainly not fresh water . I might just change both ends to be sure . Thanks again everyone

No I haven't topped it up at all . It was serviced in April, the engineer could of topped it up

Can I replace the Bush nut in situ or will I need to replace it with everything taken off ?

The water is dripping at that joint.

Good evening. My elderly baxi 105e drips from between the pressure differential valve and the Bush nut that connects it to the rest of the diverter valve. I think it only happens when I'm using hot water. Any ideas what to replace?

Forcing wax oil into the drain hole from the sills ? Will that not lock any moisture inside? Or will it drive it out ? .

You need to check if water is getting into the sill ,not sure how to do that on a polo

Maybe treat the metal first with a rust converter then prime /bodge/prime/gloss coat Use a hair dryer first

This kind of stuff ? https://www.wickes.co.uk/Wickes-PVCu-Marble-Effect-Interior-Cladding-250-x-2500mm/p/9000033772