Search results

Many thanks. It seems it is as simple as it looks. :)

Anyone? :(

I'm hoping someone can help me with this: Is it possible to remove just the blower unit from the boiler without too much hassle? I want to be able to get at the lower bearing in the fan assembly but I need to get at the underside of the blower so I can get the impeller off the motor shaft so I...

Thanks again John. :) On further reflection, I'm going to install the extra bonding in the bathroom on the tap side of the pipework This is because all the taps have compression fitting stop valves which *may* not provide a reliable connection under fault conditions. (I must confess to using...

Thanks for the reply John. Right, On further inspection the bonding is just between the pipes. No connection to earth at all (in the airing cupboard at any rate). I'm hoping(!) that he's tested continuity and found that the pipework is bonded to earth somewhere else, but would I be best off...

Hello, When we had our consumer unit replaced a couple of years ago, the electrician bonded all the pipework together in the airing cupboard. As they are bonded there, do I need additional bonding in the bathroom? (which I'm currently installing). No additional pipes have been added, just...

I'm having a little problem with a new install of one of these toilet cisterns. I've got it all connected and the low capacity flush works fine. One firm push = flush. :) The problem is with the high capacity flush, it needs to be pumped at least three times before it will flow. I've...

Thanks for the replies. :) I got a replacement motor from B&Q(spit) and fitted it last night. Job's a good 'un. The insulation on the cables had degraded and cracked with heat and age, and it had shorted to the case of the motor where the wires pass through. The valve itself seems to work...

Hi all, Hopefully this is a nice simple question with a nice simple answer! I need to replace the motor in my Honeywell diverter valve (3 port - can't see a model number on the valve, it's probably about 20 years old though!). It is currently fitted with a honeywell 4000-2737-001 motor...