Search results

I have contacted Electrium 5 times now and have had no contact back, they never answer the phone or their e-mails!!! If i cannot get around to replace them are they supposed to? Either way I need to speak to them and i can't!!!

Does the 80A 'trip' have a test button??? The B40 is a 40Amp breaker? this is to small for the shower new shower!!! THe cable should probably have its size stamped on it. Yours sounds like 6mm too me, to small!! You'll need a sparky, the work is notafiable

I use Wira, tough and don't deform or break, had my set for 5 years and just brought a new set today!!!! when training i brought Forge Steel pliers and cutters, cheap and from screw you, but, they are still sharp and going strong today!!! Brought some NWS pliers and cutters today as...

wach yer pir report t'costumer will strgle to unerstan it wif gramer n spelin that bad!!! :roll:

common thing i'm afraid!!!

Like BAS says could be 2.5/1.0. Are your batteries in your tester up to full power??

Not Bad Rob, seen worse :lol: The bunny situation has improved thou, driving throu the village late last week and one slipped under the car wheel!!!

thanks to all, BAS, expected the patronising comment :lol:

Anyone know of such a switch?

How big is this place that it requires 25 ways???? What circuits are there/ being added and on which CU? Have you done the numbers?? In the loft!! What is the reason?, would not think that is particularly 'accessible' in an emergency

Naughty Rob!!!!!!

Any suggestions on appropriate/good methods for Terminating SWA into a domestic CU. More and more work is involving external supplies and people are reluctant to have Metal CU (mainly due to aesthetics and cost). Obviously the SWA Gland nut can hold the SWA to the board and then earth via the...

I fully understand what you're asking here. I recently had to carryout a similar installation, bungalow with vaulted ceiling. I was on site from start to finish. TO satisfy LABC the cabling has been run against the joist work through 2 routes only. The cables are upto the lat work for the...

Up in yorks this next week, passing down M1 end of next week, if you 2 want to sort it out I could be the delivery boy!!! But to be honest steve nip to Chitty and buy some :)

Well illegal, not as such, just not a 'good' idea the electrician who signed this off would have serious problems arguing his case in court if something went wrong and the power could not be isolated. We need a pic in focus close up on the labels of the suspect ELCB please

Had this a few times recently, fit lights for a Lighting firm, they 'claim' to be Spanish made but the ROC stickers are every where!!! Fitted one light (£500) nothing!!!! Checked the supply all ok, no bulbs lit. Sent it back for another believing the tx was knackered, re fitted put bulbs in...

Saints Couple does the sette light up then :lol: :lol: :lol: :lol: :lol:

Hi YorksSpark, experience is a real teller, have used WAGO's and quite like them, thou not used then that often. Have not used their push fittings just the sprung clips. Most push fittings are not labelled L or N and as in the previous post this matters for ES lamps

Changing the CPD, then EIC!!!

Yep push fittings, B&Q love them, personally think they are a pile of cack!!! When you've mounted it and are absolutely happy with it all, cut the wires to length and insert them, then never go near it again!!!!