Search results

On my double stainless steel sink in the kitchen I saw loads of water onderneath in the cupboard etc. It seems the waste has come detached from the sink. It looks like it was a rubber fitment glued round the hole in the sink. Question is what to use to reattch it etc Many thanks for any help...

Two threads running got mixed up. Sorrry I'll get it sorted somehow.

Battery was outputting 6v so i presumed it was old and so replaced it. So take the loop out then put it back?

I have since turned the power off again to change the battery, the 24 hr is looped out but not the PA. Since changing the battery and turning power back on the 24 hr light is off and it seems I can arm the system. Is it Ok to run with the 24 hr permanently looped out ( obviously I would have no...

Just got back to it. Looped out the 24 hr circuit but 24 hr light still lit.

No, but could it not be a problem with a PIR or something in the panel?

Why do you think I have a cable fault?

I have an Omnicron 8000 and am constantly told it is no good and it does seem a bit dodgy at present. Bearing in mind I have no alarm experience, is there a more reliable replacement that will take the same wires i.e be obvious which wires go where, or is it time to forget it and wait till I...

Thanks, will try tomorrow

Thanks again but unfortunately this doesn't mean a thing to me. Any chance of a step by step idiots guide?

So just take the front off and put it back on again? Currently can't enter or do anything.

Don't know if it helps but the 24hr turns off when the Event replay button is pressed but comes back when Reset is pressed. Can't enter the Engineers code now, nothing happens no matter what is pressed.

After help from the forum I located my engineers code and then was able to replace a PIR. However, I can get no further as the 24 hr light on the panel is lit, it goes out when I press reset but then the internal sounder goes off. The light was on before I changed the PIR so its nothing to do...

That's great, thanks a lot. Chris

I need to replace a PIR but the terminals inside are not the same so I need some advice please. Second photo is the old one with 6 terminals across the top labelled +, -, C, N T, T and they are wired red, black,green, blue, empty, empty, then 2 terminals down the side not labelled but wired...

Old and new PIR

Now I get it, stupid Ipad auto correct feature.

The one I was dismissing was the remark that seems to be about pizza selection!