Search results

If old lawn is worth saving, rent a turf cutter , cut in strips ,roll up lawn,add top soil and relay turf.

John to his local priest. Father i would like to have a mass said for my loving dog who just died. The priest replied ,we can't do that we can only say masses for people, but if you go down the road to the protesant church they might help you. Ok said John, do you think 2000pounds will be...

Last wensday june 25th was my 42nd anniversary we both worked. I do take sandels day off like you.

When you turned your soil ,you started a new batch of weeds but only the ones in the cracks got air and light to grow, if your lawn is thick the weeds won't grow. As to the cracks or seams you can hand pull or use a weed spray keeping in mind your watering them as well as the lawn.

If you have clay you can put down 3 inch of topsoil and add turf, water well for 2 weeks. If the ground is too high, you will have to shave off to about half the depth of clay ,less in the center. The topsoil and turf will settle in time reducing the overall height.

i would guess you have sandy soil with to much drainage. If so you can dig out 1 foot of soil or build up, your choice. the new mix should be clay and peat moss, these will retain water. Also large shrubs will shade the ground retaining moisture.

use a wooden ladder as opposed to aluminium,also use a roller with a handle just long enough to reach comfortably.also rubber gloves and rubber boots to play safe.

tin baths or galvanized will rust if drilled or scratched. get a wood , plastic or metal mount and use the glue in a tube they use to join brick tops to cement walls, after it drys it will hold firmly.

try Benzine available at most pharmacies

try wd-40

Check with your local bathroom outfitter for a granite all in one bathroom counter and sink , they should have them in many colors and flecks.

I use heat shrink for binding together batteries to make packs of 6,8,10 etc. but I,m talking about 1-2 mm dia wire with insulation I can,t find heat shrink that small.

I often make battery packs but have to keep the old connectors! what i do is cut about 2" of wires along with old connector and solder new pack to old wires and connector and tape joints. It looks bad and tape comes loose on such small wire. Question-- Can I strip old insulation wire and low...

if your talking about a large flat belt, you might try (1) a junk yard with old electrical equipment. (2) industrial electrical suppliers. (3)farm equipment suppliers, better if they have old equipment.

Check around for your people that make stainless restaurant kitchen hoods and like, they might have a stainless steel expanded metal piece left over from an old range. it might need a couple of stainless bars welded to it to aid in stiffening.

If it is that crumbly, you won't be able to screw plywood to it ,as the screws won't hold. I would pour a new surface in concrete 2" thick after properly cleaning old concrete. they make special cement for thicknesses up to 2" . You might even add a wire mesh to strengthen. But talk to your...

you are looking for allan head bolts at the wrong place. Try an industrial fastener outlet. What kind of allan head bolts are you looking for? allan cap- allan button head-allan flat head etc.

measure the outside diameter of your post going into the ground and the inside diameter of a chain link fence post upright . drive post into ground 3 feet by putting a block of wood over top and hitting with a sledge hammer making sure dirt is not plugging post for the first 2 feet. insert...

try WMI (waste management industries) or your local garbage pickup . they use a powder for their garbage containers that will kill anything. Next try a carpet cleaner, they have a similar product to clean and de-smell carpets when someone dies in a house. good luck. only in canada eh!

the desk in picture looks ok for a light load, but I would add corner gussets to further support off the wall.