Search results

Hmmmmmm ok thank-you for all that info. I held the Mira shower up to pipes (they come down vertically from the loft) and seemed like they would slot in nicely. As for the transformer where would one find that? And how easy/hard is it to take it out of the equation? Many thanks

I think the two pipes line up so im ok on that score. Whats fcu?

Hi, I would like to change from an Aqualisa aqua stream thermostatic shower to a Mira event xs, the pipe work all looks the same -Is this possible and if so does anyone know of any problems that may arise? Thanks alot.

Ok, thanks again

Ok thank-you. Do I have to have the pump on to drain down?

Hi I have an aqualisa aquarian e99 shower and need to replace the cartridge as it drips. My question is, does anyone know how it comes apart? Thank-you

I would like to paint a grey plastic soil pipe black - Does anyone know of any good paint that will cover this and not flake off. Many thanks

Thats what ive fitted but thankyou for advice

I recently changed the element on a cylinder, and now its started leaking...if I have cross threaded it can anything be done about this or is it a new cylinder? The cylinder isnt that old 2007 but its a really hard water area and the element has been changed quite alot and the thread was a...

Hi, I need to raise a shower corner tray, what is the best material to use to raise it up? And would building it in a square shape suffice or do I need to take on board the curve? Thanks

Quick question: I have a Stack with the WC waste coming in on the left and would like to bring the shower and basin (as one) at the front, there is a cut out for this but its at the same height as the swept WC - is this ok according to regulations? Thanks

Hi all, I have an under mount kitchen sink to fix to a solid wooden work top, the fixings that came with it are some small flat pieces of metal with holes in the middle and raised ends, some screws and some cylinder shape raw plugs with thread on the outside...... Do I drill a hole for the...

Ah but thanks for the link, didnt realise you could buy them that big (actress, bishop)

Oh Freddy, EVIL! Pure evil!

Damn this site use to be good once upon a time

Thanks, yes I should just stop being tight!

I have drill bits and spinners (wood bits) but nothing that is 38mm, is there anytricks of the trade at using what I have and still coming up with a nice neat hole? Many thanks

I completely agree!!!

Hi, I fitted a replacement Wickes sanipump, the newer model was slightly bigger and less wattage I think, it has the WC, small basin and bath that go into it. I had to slightly raise it off the floor one side(about 1inch) because of fitting it in with the existing pipework. It works perfectly...

Yea but will I need to get an electrian to install an MCB? All that is there is a 30AMP seperate fused wire?