Search results

Hi all, have a Honda Accord Aerodeck 2.2 1994, is there an easy way of telling if the cam belt is broken, as car will not start want to make sure before we keep turning over as when engine is turned over it sounds different. Thanks for your time.

Thanks guy's running now. :D

Hi all, car has not been used for about four days, went to start it turned over for a few seconds and nothing, put jump leads on which turned it over as normal but engine still not firing. Noticed that there appeared to be a lot of damp from this fog over the engine electrics, my question is...

Thanks guy's, very usefull infomation.

Hi Chris thanks for your input m8, exactly the info I was after.

Hi all, am after a MP3 Player with a playlist so I can organise my music to my liking, but when I search it says nothing about playlists so what should I look for and do any of you have any recommendations up to £50-00. Thanks and Merry Christmas.

Thanks for that foxhole, appreciate your time.

Hi all, have a small toilet with vinyl tiles on the floor, my question is can I tile over the top with more vinyl tiles, if so what is best to clean them with before new tiles are laid. Or will they have to come up. Thanks.

Thanks for your input guys will be taking your advice, appreciated.

Hi all, have an electric shower downstairs next to a utility room where the consumer fuses are, the shower has a 45amp mcb (on 10mm cable) which is also used to isolate shower when not in use. My question, is it ok to use like this or doe's there have to be an isolation switch in between the...

Hi all, I am looking to hire a carpet cleaner which has attatchments for some awkward corners, as we all know there are good and bad, so some recommendations would be appreciated. Also any tips on using it. Thanks for your time.

Hi all, we are having a conversation at work about T.R.V's. can someone settle an argument, you have a rad off the wall and no decorators cap on the trv and the heating system is switched off ie power to the boiler and there is a hard frost would the uncapped valve open and leak water. Also...

Hi all have a Hotpoint Aquarius WF240, the problem is at the back of the facia (where all the buttons and lights are) there is a circuit board. What has happened is that where it has been turned off and on so many times the board get's pushed back into the machine out of it's clips, and now it...

Hi all. is there an easily available universal thermostatic rad valve cap to cap valve after rad removal, or any suggestion on anything else that can be used. Thanks for your time.

Hi noseall, the problem is two fold, firstly there was a leak under the bath and secondly there was no air vents under the floor, so under bath wet rot, rest of room dry rot. Was thinking of claiming off insurance but would they want to know as the job wasn't done properly in the first place...

Hi all, have a timber floor which is rotten, laid on a concrete sub base which appears to be solid, they have laid 3"x 2" timbers flat with chipboard on top and then tiled. Want to replace wooden floor with extra DPM, insulation and a screed over the top. I know that the 2" insulation should be...

Hi Chris thanks for your input, will be taking your advice. Thanks for your time m8. :D

Hi all, have a Bungalow, two bathrooms and a kitchen, all fed off a tank in the roof and cylinder at ground level. The hot water to one of our bathrooms is pumped, the problem is that you turn hot tap on water runs fine for a few seconds and then stops and so doe's the pump, you get a trickle...

Hi all, have a Honda Accord Aerodeck 2.2 1994 M Reg. The clutch pedal seems a bit floppy, in other words had to travel before any resistance, over the last few days and now its worse although I can change gear ok. It seems a bit like when your brake fluid has got very low, I was wondering is...

If you have concrete as a base and it is solid why do you need slabs??