Search results

This type

Are the riser kits for shower trays with the threaded bar that screws in to the tray any good?

I'll have a site search

Is working for the councils as a plumber good? There is a few perks big holidays sick pay etc

It's honey cone but 10mm

End caps for the top. But I need it to be decent where it sits on the bath

The ends look like this on both sides. Would probably have to cut the bottom of it off to get a decent edge to fit in the bath.

Has anyone used the 10mm plastic paneling?

It's sv92467 ideal standard. But I think it's been discontinued

It would fit in the the ideal standard carrier?

Hi does anyone know if you can still get this flush valve? I know it's ideal standard thanks. I'm hoping to get the same.one so it with twist out of the Carrier. Otherwise I will have to take the toilet out. Thanks.

Thanks yes I'm frightened of disturbing in the wall as it all tiled in etc. Thanks

See attached

I have a leak on a bar shower mixer valve. To unscrew and replace the washer do I need to hold back on the 3/4 thread somehow?

Anyone fit filling loop Isos. For isolation and dcv on outside taps?

The pump is working but it could of got lazy? It's a grundfos 15/60. The 3 port valve is new.

The pipework is 22mm main runs reduced to 15mm to the drops then 8mm drops. Up stairs rads 8mm too. 15mm pipes to the skirting boards then 8mm from there to the rads.

It's a opened vented Y-plan. 11 rads. Ideal classic.

What could be causing this. It isn't a sludge problem as the system has been flushed. Thanks

What would be the usually amount of time to set it to run for after each pressure drop? Is only a small cistern 2 urinals