Search results

Can anyone help i have been having problems with this boiler running for a day then locking out, it has a new burner on and the combustion is stop on, all baffles are correct and flue is not blocked , it is a oil boiler, there is plenty of oil and oil line is clear. haS anyone got any...

hot water not getting as hot as it should be any surgestions

co2 is out on full load bet there is only one adjustment on gv goes all over when i go back to part load , instructions in germany no help at all :mrgreen:

Is there a high and low fire adjustment to set up on the gas valve to get the correct combustion readings . i no there is one but cant find adjustment for other. :shock:

Could anyone help i am going to decorate my utility room but the paint is peeling of in places, i am wondering weather to get the room replastered or is there any way of painting over the walls or do i need to scrape the paint of any help please. :mrgreen:

:o Hi, I am just wondering about boiler ventiltion , is there a difference in ventilation up60kw and over 60kw I have looked for information about high and low but am unable to locate anything, i think you need around 2cm per kw ,but im not sure if that is for high or low or both, if anyone...

I have a problem with a 25/32 oil fired combi, the boiler runs for maybe an hour or so then locks out , resets ok then might run for a day or so then locks out again, i have put a new nozzle in and the pump pressure seems fine . all baffles are clear and flue is not blocked. sometimes when the...

it was the pcb , thanks for your help. :)

dont think so but ware would the over heat switch be. cannot see one .

The blr does not fire up but there is power coming into the pcb and out to the control stat. The room stat is working and the clock is asking for heat, I think the pcb has gone because the burner is not trying to fire and everything is ran of the board, if anyone has any ideas , or any other...

Can anyone help, a friend of mine has a baxi solo condensing blr not sure what model, but they say the hot water starts of well then gets hoter and hoter . they say blr is only two years old, apart from that i dont know anything else. 8) 8)

i just went in manual and went through fault codes, will check if boiler fires on and of thanks

Hi everyone could someone please help, ive been having problems with my hot water it runs hot and cold . i have changed the hot water sensor but the problem has not fixed, can anyone help. also someone has mentioned fitting a magnaclean to the system would help stop iron fileings entering the...

Ihave a question for some decent plumbers, i have some speedfit pipe but have a load of hep fittings which inserts would you use , hep or speedfit inserts or can you use both. :P

no it does not fill with water , are the motor brushers hard to change and where would you get them from. cheers

I have a indiset 1100 wib111 once i shut the door and turn on the power some times the machine starts but does not spin i have checked the belt and it is fine, please help

You can buy avanta 28c complete with jig valves and filling loop well worth the buy plus you get five year warranty. think you only get two years with the eco model. Boiler is little more expensive but worth it

viessmann 200 30kw condensing boiler. hot water not reaching set point temperature, will only reach 47 hot water plate heat exchanger is clear. hot water will reach temp when heating is on.