Search results

what the best glue to stick these to the door frames would you say anybody???,,,need something thatll go on thin as theres only the few mill gap what the saw went through,,,anybody???

its not a normal oil filter mate,,,its a plastic housing with a 27mm plastic nut built into the end,,,unscrews easy enough but the actual oil filter which sits inside of it is pushed in and plastic tabs clip over it inside,,,to get it out of the plastic housing without breaking the plastic tabs...

hello,,,just gave my focus a service today,,,new oil and filters,,,all straight forward enough apart from the oil filter what sits in the plastic housing that has to be unscrewed from engine,,,it has plastic tabs holding it in and only after watching a youtube video and rolling up some cardboard...

i went for the same dewalt also mate,,,after reading a lot of reviews on each drill this one seemed the one to get,,,with the erbauer core drill set,,,is it just me or do other people love buying new tools,,,???,,,I enjoy going to the tool shop just as much as buying new...

hello can any of you lads recommend a decent core drill to buy,,,ive had enough of hiring them and fancy my own,,,the last couple Ive hired one nearly tore my arms out the sockets when drilling around 10 holes,,,not sure what make it was,,,kept spinning out of my grip no matter how tight i held...

that was my first idea mate when I first looked at it,,,may still do that yet we shall see,,,thanks for the reply...

i doubt it mate,,,the gap on some frames is 35mm and it hasn't been done neat,,,they haven't even used a piece of the flooring as a guide for the saw,,,its just been hacked at and is mostly uneven cuts,,,id have to undercut it even more to say 40mm if I want to repair it properly,,,first I was...

carpet mate...

sounds good,,,would you use the use the grip fill on the top of the shaped piece and fix to the underside of the frame and leave slight gap underneath the shaped piece so its not actually touching the chipboard floor???,,,is that the same as pink grip???

Hello i was wondering what would be the best way to repair the bottom of my door frames,,,previous owner has cut around 25mm off the bottom to accomodate some oak flooring which i have taken up,,,any ideas anyone,,,???

thanks for all your replies lads,,,its great to be able to get some advice on here,,,much appreciated...

so wiring the stat to the boiler in this way could not damage the pcb to make the boiler act erratically like it has been ???,,,would any guarantees be invalid if wired in this way???,,,its obviously not the way its supposed to be wired in...

after just watching a video on youtube on how to wire these stats in it beggars belief that anyone could get this wrong never mind a qualified heating engineer,,,two 2 core cables from stat receiver box,,,one joined to existing live and neutral on boiler,,,the other would be your switching cable...

the stat wires - neutral has been stuck in with neutral from the power wire,,,live has been stuck in with live from the power wire,,,and earth has been stuck in line 1 of the stat terminals,,,??? but painted black with marker pen...

I'm no electritian or heating engineer but that wiring doesn't seem to match up with the instructions to me??? any thoughts anybody,,,the mains are switched off and I don't intend to touch anything myself,,,i just wanted a quick look in out of curiousity as the boiler is acting very...

.

for future reference,,,is it better to drill the holes in the mortar line or onto the bricks???,,,the holes I already have are in the bricks,,,two in each...

just a bit rising damp mate on the wall between my and my neighbours terrace houses,,,its been damp coursed before in the past as the all the holes are there when I popped the skirting off and its been done a metre high in sand and cement,,,i was just gonna clean the holes out and squirt some...

hello,,,can anybody recommend a good damp proofing cream,,,ye know the type ye squirt in the holes with a mastic gun etc,,,???