Search results

What is the recommended insulation requirements between the Joist, on a cold flat roof installation. To prevent condensation, I will be leaving a 50mm air flow gap between decking a insulation.

Still having difficulties to install. Side trim noted to have some internal damage. This was caused by nylon tape installed by the suppler. You had to pull the tape to fully release trims on the side lights. See Photo. Informed supplier for replacement parts

Just removed 3 rows of tiles to allow for EPDM overlap from our new flat roof extension. Unfortunately 2 of the large valley tiles discovered broken, including some of the cut tiles. Our replacement valley easy to obtain, or is there an alternative valley replacement method for this section.

Just installed French door with sides lights from Wickes. Attempting to reinstall the glass units to the side lights, but cannot get the flaming window side beads to fit. Instructions asks for the top & bottom first, then the flaming sides. Any Ideas?

The hinge is upside down on the door and not the frame.

Just installed a UPVC French door with side lights from Wickes. I went to hang the doors to discover that the top hinge on the slave door was fitted upside down. http://www.wickes.co.uk/pvcu-french-door-with-2-side-sash-panels/invt/155265/ I've had these doors (packaged) for 12 months, due...

Hinge

Just about to fix in place my French Door with side light. I noted to have a 20mm gap on the vertical. I managed to put the unit on 10mm broardfix packers. Question 1. Are packers OK to be used on the bottom ? (5 U Packers used) 2. How do I infill the remaining gaps ? Can I use...

[/url] urgent job which need doing. ie will the weather last

If I use plywood what thickness is recommended and can this be fixed directly onto the rafters. ie 3.6mm http://www.wickes.co.uk/hardwood-plywood-6x606x1220mm/invt/111195/

1. What size would a cocking fillet need to be ? 2. I have plenty of spare OSB 3 off cuts. Could this be used for layer board under the tiles, instead of plywood?

Who supplies cocking fillets and what size?

Woody I've never used sarkings. What would you recommend and tips diagrams.

How far does the EPDM have to go up against the joining pitches tiled roof. I suspect 2 tiles. If this is correct do I remove the 2 roof battens and replace when the EPDM is fitted.

herringbone would save a lot of time and hassle, only if this is a correct suitable method.

Herringbone Strap 400 mm or noggins, for mid span on flat roof decking?