Search results

when you change an immersion cylinder do you drain the heating system from a rad drain off or is it easier to crack the fittings to the flow and return on the coil and catch the water there.

can anyone give any advice on changing these, ive been told you have to drop the whole rear subframe! seems a bit extreme to me.

turbo pipe i checked the pipe and it DID have a split in it, i put a new one on and also cleaned the egr valve while i was at it. works great and no black smoke, but the engine light is still on. will this go off eventually or does it need resetting in some way.

hello i have a neff washerdryer, the tumble dryer part of it is not getting hot, can anybody help thanks

hello. im changing a rad valve and wanted to know when i drain the system is it best to turn all valves off at the other rads. also got a couple of extension tails with o rings on them, i take it there is no need to ptfe the threads when i fix them into the rads. i just want to make sure...

oh right, thanks, i'll have a look at that

thanks is it poss that it might be too much pressure and that it could be turned back a little at the mains, if not i'll have a look about.

burnerman the pipes rumble while it is running, would i use a shock arrestor for this and are they easy to install. andy i did a plumbing course for a year so know basic domestic stuff, but anything to do with boilers is beyond my capabilities,

no why?

when hot tap is turned on. don't know system as described to me over the phone. but the tap that was turned on was not near the boiler when it was heard

hello i,ve got to look at some rumbling pipes, to start with i thought it might just be a case of needing a clip or two but i've been told it only happens with the hot water and it seems to go back to the boiler but they are not sure, bit stuck , any ideas. thanks

thanks. i'll start with descaler and see how it goes

the reason i need one is the end of the spout is scaled up, and looks like somebodys been jabbing something up there so when cold water is turned on it comes out at all different angles,

could anybody tell me where i might be able to get hold of swivel spout for mixer taps without buying the whole tap.

ok thanx, but when i lay the weak sand/cement mix do i spray with water before laying them

Hello Is it necessary to have cement with sharp sand as a base, or can I just use sharp sand, and use the cement for the grouting? Thanks

hello i've got some patio slab moulds, but can anyone tell me the best mix to use and to what ratio thanks

thats good enough for me. thanks alot

thanks very much. why do i need to leave 25mm short of floor

Hello I have a few questions as i know nothing about plastering. Is it ok to plasterboard a conservatory dwarf wall and also the external wall that the conservatory is attached to ? also what type of plasterboard should i use that i can paint straight over. also what type of fixings should...