Search results

Yes, I tried Continuous and Quick dehumidifier modes. Very certain tank is installed correctly. Will take it back to the shop to see what they say

Hello This is my first time using a dehumidifier so I am not sure if my dehumidifier is working properly. I got a new Wessex dehumidifier. It's been on for more than 24 hours but has not collected a single drop of water. It also emits cold air ( I was expecting it to emit warm air). I have...

This one fits perfectly. Thanks @jj4091

Thanks for the replies. I was dreading i may have to get a new worktop

Thanks for all the replies. I did try to look for the brand of guttering, but couldn't find it on the gutter. The above link looks promising but it mentions that its "116mm wide". I measured my current gutter and it seems to be 120mm wide so not sure if this is the right one: I measured it from...

My worktop behind the sink is rotting. It has become detached from the sink and from the tiles. The water can seep through easily. Also, it has some holes which I am covering with black duct tape. I have also used a lot of silicone to fill the gap between the worktop and titles. The silicone...

HI I have a conservatory whose gutter stop end has broken off. So I am looking for a new one and I can't figure out which one I need. With my research I found out that I need ogee stop end. So I bought one but it's not the right size. Before I buy another one, are you able to give me any...

My Candy washing machine has started dripping underneath. I suspect it’s leaking near the filter area. I have cleaned the filter. Propeller also turns. Cannot see anything obvious in there. I don’t notice it dripping when the machine is filling. It starts happening sometimes in the middle or...

Wonderful. Thanks for the advice

Due to high winds, some of the plaster / cement around my roof tiles has come off. Please see picture. Is this a diy job or do I need a roofer. If it’s a diy job, what material do I need? Thanks

Its a Belling range cooker. I have attached picture of other burner at full speed. I have cleaned the little hole circled red in the original picture. I am just wondering if its a cleaning job that will help the flame to fully spread around.

The main burner of my gas cooker is not spreading the flame around. The flame is mainly coming from the middle. I have given it a thorough clean, specially used a needle to clean the gas chamber (circled red). After cleaning, I got more flame in the middle and its still not spreading around...

Yes, humidity and a small extractor fan has been a problem in this bathroom.

Thanks freddiemercurystwin I take solace in the fact that at least I gave it a thought.

Hello My IKEA bathroom cabinet has started to rot, such as sink side panel and cabinet doors. What are the ways I can prolong its life and make it aesthetically pleasing. Please see pictures attached. Thanks.

Have tried with new batteries but no success. These thermostats from CENTER are really bad quality. This is the 2nd thermostat from CENTER that has packed in in the last 3 years

A really silly question. My wireless boiler thermostat controller has packed in. How do I turn on / off my radiators without using thermostat? How do I set temperature without the thermostat? Cannot see any button on my boiler to turn it on. It’s a Greenstar i boiler Thanks.

Thanks for all the replies. I did use cotton thread. Nut is a bit tight now but still does not screw to the end of cistern. It becomes loose. Most probably need to get a new one.

I bought this flush handle only few months ago from a local DIY shop and now the handle has become loose. I have tried to tighten the lever nut but it does not fit properly and becomes loose again. What are my options? Shall I try to get a metal/brass level nut and see if that works? Would...

Aah, I never looked at it from this perspective.