Search results

Another texecom question. Whilst I have building work going on at my house I want to use the control timers to turn on the alarm at evening and off in morning so I don't need to rely on the builders to set it or struggle turning it off. However whilst I can set days and times I can't get it to...

Hi. My electrician helpfully decided to run cat5 cable to all sensor points when I asked him to wire the house for an alarm during first fix and I only realised once it was plastered. I have just about managed to wire on the keypads and PIRs but the panel is impossible as the cores keep snapping...

Yes I did the neostat install in a complete refurb. The electric neostat are direct replacements for any standard electric start and I have mine connected to the sensor buried in the floor, and the sensor in the stat turned off. Yes the neostat need to be wired back to the boiler and I have...

Just re read your post. My plumber wasnt familiar with heatmiser so I called their technical line a few times. Both to get help designing system then for wiring plans for my plumber. They were very helpful everytime.

I looked at both of these and ended up going with heatmiser neo. We have 4 x water UFH zones, 3 x rad zones, 3 x electric UFH, 3 x electric towel rails and the hw timer all set up and officially supported and all controlled from phone . Yes doesn't have quite same functionality of heat genius...

Thanks. So you run the trunking all the way behind the panel. Sounds more secure that way, I was just planning on putting the trunking to the edge so concerned that the cable would be exposed behind. Guess by the time someone has found panel, realised where cables are weakest and cut them the...

I got them both from diy-alarms.co.uk

This is the feet. Basically holds the back of the panel 8mm away from the wall. At the moment it's screwed to the side of the panel whilst I decide on location. Thankfully got 2 panels wired in and tested nice and easily. Thanks for the mains cable comment. It's in the same cupboard as...

Hi I am just starting the actual install of my premier elite 24 after having spent a few weeks on here and wiring up keypads and PIRs on the kitchen table. The panel is going into a cupboard in the utility room and I am struggling with placement and cable runs. All the wiring for sensors was...