Search results

hi all We have a 2003 Toyota Corolla verso, the mrs has informed me that the yellow, engine shaped warning light has come on. Can anyone tell me what it means, the handbook just say take it to a Toyota dealer, but then it says the same for anything more serious than a dirty window. We are just...

Putting the right screw back in the right ole by any chance?

as above really, the car has to go for an mot, I've checked everything works ok, just the passenger door mirror is cracked, will it fail? TIA

:LOL::LOL:

above dishwasher has next to no flow to bottom sprayer, top seems ok, top rack only button not pressed by mistake. Removed spray arms and run with door open, still no flow to bottom top ok, I've tried to hold my hand over the top spray bar exit to force flow to bottom one, with no joy, checked...

Looks like the night map on my sat nav

If it is a cx its a combi

Can't you leave a bath tap running very slowly, leave the plug in then use that water for flushing the toilet etc?

When they work properly,the response is actually a good boiler,I think I'm right in saying that the heat exchanger is no longer available, but someone may correct me soon,you've had a good run,if it goes again,may be time to think of replacing it.

Try reading the post above your last one!!

All may not be lost yet!! Had another look, and started the dryer to see what it did,and the element did heat up again,but shut off and stayed off as soon as it reversed direction. Then I realised it must be looking for some airflow over the element and thermistors,which it wouldn't have with...

Thanks,I'll have another look tomorrow. Thanks again for all the advice

The results were with the power of,the element is broken,the centre part not the coil. The machine still runs but without the elements heating up.

NOOOOO not OL 0.00 ohms :roll:

Decided to crack straight on with it as the Mrs had some boring costume drama on,now wish I hadnt. Top stat 48.5 but garage is freezing cold,bottom one OL I ran the machine with back cover off to check the elements, only the top 2 glowed red,the bottom one didn't,should that be the case...

Ok will check all points you've mentioned,will post back in next day or so,thanks for all the advice.

Right multimeter set to 200k, cold 43.8 (dryer lives in garage at bottom of the garden so very cold) warmed in front of fan heater drops to 2.8 but probably much hotter than dryer would actually get. Filter light does not come on when door opened on mine either. Only one fan,it's rotor looks...

Yes.

Stripped all the air ductwork out and cleaned any stuck fluff deposits, but still tripped out when tested. I did find the sensor at the top of the drum,and wondered if that was a sort of overheat type sensor,so I made up a blank plate to replace it and left it dangling outside its housing to...

Thanks I'll have a look at the points you've mentioned. I'm picking up a used hot point dryer I've got as part payment for some plumbing work,so at least I'll have a dryer while I clean out this one