Search results

Hi, I have a standard metal box sunk into a solid wall with a blanking plate being used as a junction box. I have utilised this to wire an extractor fan, changing the blanking plate for a switched fcu. However, due to the addition of a third set of wires and the bulk of the back of the fcu...

Hi, any ideas how best to lay trunking down a wall where the bottom half of the wall is tiled. i.e. hoew to negotiate the lip where the tiles start? I have thought of fixing a slim piece of timber the same width as the trunking onto the plaster and then laying the trunking on top thereby...

Need to mix powdered plant food so ned container and plants are at ground level so simply tipping the can wouls be all that was required Thanks for the responses tho

Hi, does anyone know where I can get such a thing to avoid my father bending to pick up a full watering can? (the alternative would be to raise the height of the outside tap and build a stand to sit the can on when filling) However, a long handled watering can would be the far easier option...

Hi, sorry if this question has been asked before, can anyone give me advice on how to clean fence stain off concrete posts? :?

hi, Thanks for the response .. replies are getting more poitive! Please advise on how to measure the current drawn. :? Thanks

Hi, the model I bought is thermostatic sealed with electric element fitted at a cost of £155! This is one of the features of the shower room I did not cut corners on as adequate heat was essential as the room has two external walls and would (and has) become a "no-go" area in the colder...

Hi, I have recently purchased a ladder radiator for my downstairs shower room. It came with an electric element (already fitted and sealed) and a thermostat I fitted separately. Based on the measurements of the room and the passage way outside it (separated by a door), degree of insulation...

Hi. I see what you mean and it would work if the tiles were laid vertically but horizontally I would have the sam problem everyy other row. However, due to the thickness of the tiles I was aiming to avoid cutting altogether. Maybe upvc strips against the cubicle edges and a clean joint with...

Hi, they are purchased but not fitted yet

Hi, I am tiling inside a corner shower cubicle. I am using 33.5cm x 25cm tiles laid horizontally 2 tiles wide on each of the 2 walls. The total coverage i.e. tile + grout + tile leaves me approx 10mm short on each wall. Is there anything on the market like say upvc quadrant to fit in the corner...

Hi, element was pre fitted and the thermostat/cable supplied separately. No markings on either!

Hi, I got the BTU from the link below: http://www.lunaspas.co.uk/acatalog/White_flat_electric_ladder_rail_750.html Have I calculated correctly?

Thanks I take it that generally speaking Watts/Volts = Amps. So, 538/230=2.4, therefore 3 Amp fuse Thanks a alot

Hi, 1835 BTU using conversion rate 0.293 = 538Watts

Hi as advised on an earlier post I have wired as follows: 2.5mm to FCU - 1.5mm from FCU to timer - 1.5mm from timer to ladder rad Please advise what size fuse to use in FCU ..... 13A ok?