Search results

  1. RF Lighting

    Is there a reliable flush mount ceiling occupancy sensor anyone could recommend?

    Sounds like you’ve installed microwave detectors if they are triggering with the door closed. You would maybe be better off installing a PIR detector instead. As already mentioned, timeguard are a good make. I look after a site with lots of them an they seem very reliable. Also they use relay...
  2. RF Lighting

    Unusual item

    I was snooping around in our main LV switchroom today and spotted this: We have a 2kA per phase supply fed in to our panel board from an 11kV sub at the other side of the wall in the picture (to which we don’t have access) The cable from the break glass unit disappears through the wall into...
  3. RF Lighting

    does 6mm bonding to water pipe have to changed ..

    It depends on the supply type to the property, but it will often be replaced as part of the consumer unit replacement works
  4. RF Lighting

    Switched Emergency Bulkhead tripping RCD

    How new or old is the switch? Although it seems strange I’ve found switches which have poor contacts and arc excessively when operated can sometimes cause RCDs to trip. Do you have a spare switch you could try in place of the existing to rule it in or out?
  5. RF Lighting

    British Standard for USB built into wall sockets?

    I fitted 2x lap Euro module usb chargers at my sisters house. They were both used to charge a smart phone and or tablet nightly. Both failed within 2 years and both tripped the RCBO when they died within weeks of each other but failed open circuit so the RCBO could be reset.
  6. RF Lighting

    Light spacing

    The standard spacing I generally use is 600mm from each wall and then every 1200mm in between
  7. RF Lighting

    No void for junction box...

    It’s absolutely fine to joint the wires inside the new light as long as there’s enough room to physically get them in there.
  8. RF Lighting

    LED GU5.3 Lamps Running Off SELV Transformers

    I’m not familiar with the transformers you mention. Are they wire wound or electronic? Is it set up with one transformer per light? Can the transformers be easily pulled through the downlighter holes?
  9. RF Lighting

    Filling behind back boxes

    Expanding foam works a treat
  10. RF Lighting

    led light strobing

    I prefer “chauffeur” to be honest
  11. RF Lighting

    1.5mm2 cable for single socket?

    Well done. I’m proud of you.
  12. RF Lighting

    Electric Underfloor Heating

    No I’m asking you.
  13. RF Lighting

    1.5mm2 cable for single socket?

    You used the wrong name at work then.
  14. RF Lighting

    1.5mm2 cable for single socket?

    Will a 13A fuse fail before a 1.5mm² cable?
  15. RF Lighting

    1.5mm2 cable for single socket?

    No. 4 way splitter is the wrong name for it.
  16. RF Lighting

    1.5mm2 cable for single socket?

    Ahh ok a fused device which will limit the load to a maximum of 13A regardless of how many heaters you decide to plug in to it then. What exactly was the point you were failing to make?
  17. RF Lighting

    Electric Underfloor Heating

    Just post some proof. It’s really not a difficult request if what you say is actually true.
  18. RF Lighting

    Electric Underfloor Heating

    All lies which you have posted on this forum.
Back
Top