Search results

cheers for the reply is this a common fault....guess it must be over 10 years old?

All signals seem to be correct to valve..is it possible for the valve to become sluggish when changing position? from hw alone to ch alone valve arm moves..all though very slowly (guess this is normal) and from ch alone to hw alone valve moves ok. When on ch and then turn on hw it will move...

yes im sure of that to..just cant get to grips with the stat..i replaced a rte1 with rts4 thought i had followed the swap over correct..trying to find wiring info

Cheers for the reply....hw on only does what it says...only to cylinder ch on only stat operates heating perfect both on together somehow the rads are scorching hot,even with the stat turned right down i think the rads,with the ch on are being controlled by the cylinder termostat...is that...

I have skimmed on to these concrete panels...but surely got to be better to take down a pack out to get it plumb...must be screwed on????

have a glowworm boiler,with drayton 3 port valve,recently replaced room termostat with new drayton,and this set up require three wires to the stat, plus honeywell programmer.since then when heating is on alone, stat operates perfectly,here the click at temp setting,raise the stat and boiler...

Yeah thought something along those lines..cheers for your time all. Jacko

Cheers RF check this out!! http://www.rangecookers.co.uk/Product.aspx?id=357#spec

I am moving theorigianl oak lintel to a higher position in the chimney breast to allow the cooker to go into the opening,but i need to run cables as there will be no access for the cooker fitters,was just interested as to the high rating of the switch

Got the spec sheet yes a big mother f**ker will 10mm cable suffice as well as this 67amp switch????

Range cooker at 15.6kw..spec sheet requirea cooker box at 67.8 amps..is there such a thing.looked on Mk and can find 45amp any body shed some light? Cheers

Was it porn?????? lol

Yes am finding it difficult to keep a level adhesive.especially when fitting a heated floor mat.maybe i am putting on to much to cover the mat?????

Am unable to open the link...thnks for getting back to me, thought it required some sort of guide.

Hi J, you gave me details recently for diamond hole saws from richon .Hong Kong, they arrived but minus an arbour/drill guide..how do you mange to use them with out slipping. cheers Jack'o

been laying a tile floor recently,I think i must be knocking up the adhesive to wet,as when i lay the tiles on to the notched bed i get the adhesive forcing its way out of the joints..result loads of cleaning up. could this be the prob? Cheers

Cheers guys......

advice as to the fitting required to mount the fixed arm into the supply pipework,the arm has a 15mm male thread,if i fit a compression elbow,it requires me to get access to tighten the nut,is there an elbow with a normal connection to 15mm copper and female entry to allow me to screw in the...

come across lately,porcelain,and incredibly hard tile surfaces,not only the glaze,but through the whole tile depth.just burn out tile drills or head snaps,have heard of water cooled drills available,what joy have you guys had dealing with this prob? Cheers

yes linked from the first switch, have tested the continuity and all three cables to other switch, seem ok. although only joined them together at the first switch end how can i test which one might be at fault?