Search results

Hi all, About a year ago I've got a small toilet-shower installed under the stairs. Yesterday the shower drain got clogged and I have used some chemicals, hot water and finally a plunger to unclog it. After using the plunger the hole drain pipe has come off . As you can see in the picture it...

Thanks for advice. It looks more complicated than I thought. Time to buy a new one

I know I can replace dongles or buy a new mouse. Its not about expenditure. I just would like to see if someone has tried this before. In RC models if two people are flying with the same frequency you only need to change the receiver Chrystal in the remote control and plane. I was hoping for a...

Well its meant to be a challenge...

Hi all, I have two computer mice one with a dongle that is falling into pieces and one similar but without a dongle. My plan was to swap some of the electronic components from the mouse with dongle to the mouse without the dongle in order to have a good mouse. I have attached pictures of the...

It is a Diesel indeed. 1.9

Thanks . This helps a lot

Thanks for quick reply! The guy estimates £120 each side. Is that a fair price??

Dear All, My 2001 failed the MOT because of a leak in the rubber seal as shown in the picture. I am not an expert mechanic but would like to appreciate any expert advice as I have some doubts about the garage honesty. Both seals have the same failure. The garage said that they need to replace...

Thanks all. They are at last 20 years old. But in any case I know now how much they can ask me for replacing them. Thanks

Dear all, I have these three windows where the double glazing has failed. Before asking for a quote, can they be fixed or do they have to be replaced? Anyone has any idea how much can it cost ? many thanks

Thanks!

Hi all, I am having my gas meter moved into the garage where the boiler is also located. I need to re-connect the gas meter to the boiler.They are in the same wall and separated a distance of approx 3 meters. I am in Hampshire, how much can I expect to be charged by a gas safe engineer? Thanks

Thanks!. I do not think it is a push up. If it is threaded then it has welded together. In any case sully design! Thanks

Anyone knows how to replace the bulb in this bathroom lamp? The glass seems to be fixed to the metal. There are not side screws or any obvious way of removing the glass.

Sorry for late reply. Thanks for all advice. My underfloor is electric and SG provides me with both gas and electrics

hi all, I am about to install the extractor fan in my new kitchen. I heard that there must me a minimum of 700mm between the extractor and the hob. But i also heard that it depends on the type of hob, i.e. Gas, electric. Anyone can confirm what the regulation says?

Hi thanks for response. The roof has got a small angle down to a gutter. The cap sheet is around 2cm above the bitumen. I guess the next step above would have been too high? Can you clarify what do you mean with the angle fillet at the abutment? The gap is around 20cm, the plan is to cut a...

Are the pictures big enough? If silicone should be applied, what type?