Search results

Hi. Is there a best way to "Glue" PIR to a concrete floor. I have an existing screed of 70mm that I am replacing with 20mm PIR and 50mm flowing screed, just wanted to make the boards a little more secure while installing UFH pipes, etc. My plan was for a few blobs of spray foam with a few...

Hi. Just knocked through to a new rear extension. There was a sliding door so the cavity looks full to the top, strangely the whole cavity lokos to be part full as well, debris form the knock through maybe? What is best practice how to deal with cavity? Just concrete it in?

Finally got round to putting the fascia up after being lazy over Christmas. Roof has been signed off by building control. Next visit is completion.

Extension is 11m x 4m.

Message

Rear doors are in! 1 side window to install and I think I'm water tight............. Wasn't going anywhere near these. supplied and FITTED!

GRP/Fibreglass. A pain due to the up stands for the Lanterns. Although I think any roofing sytem would have been a pain with them. So far so good, but with any flat roof system only time will tell.

I'd say about £600 on tools, I already had a few bits. Budget is currently on track for the extension. Issue is as always once you start, it leads to other things... Summerhouse in the garden 3K New fence behind the summerhouse 1.5K Gabion wall to increase the grass area using soil dug up from...

Roof Lanterns finally in. Guttering and the flashing for where the extension joins the house and the roof will be complete.

Thanks. The sealant is to be used as below in the diagram.

Hi. Not sure if this should be here or in windows and glazing. Any particular/preferred sealant for installing a aluminium roof lantern onto a GRP roof. I'm assuming a good quality frame sealant is what is needed? Cheers.

New foundations went as deep as the existing house. 1.8m if I remember. Think the plot is on a slight slope and there are some large trees in the back garden which may have been the reason.

Roof is now 99% done. Pain to try and fit in a couple of dry days! I never want to mix a batch of resin again.

It's the future! Hopefully get the roof finished this weekend if it stays dry.....

Hoping to get the roof complete this weekend.

More framing and VCL.

It's not that hard. YouTube and asking lots of questions on here.

Thanks. Can't go the glue route as my vapour control layer isn't fixed to the lower deck. Off to Toolstation I go!

But the deck does need to fixed somehow. The question was if long screws were the way forward. Cheers.