Search results

I am away from the house today but will get a pic asap. I also need to get the exact measurements of the hole that the vent fits into (apologies for posting without these exact details) However, the soffit essentially looks like the rectangular one below except it is made of a rectangle of...

Hi, I need to fix about four fine mesh wire soffit vents. They are roughly about 15x7cm. Either they have rusted or have been pecked by birds. So far have kept birds out with some duct tape but need to fix vents so they can do their job!! Problem is that the very fine mesh is sold in huge...

I found that I had read only half the many posts on this subject but I would still like to hear your views on here A solution may be to: 1) replace 45A cooker switch and socket with just 45A cooker switch 2) replace cooker connector plate behind cooker with two unswitched 13A sockets...

Hi I am getting a dual fuel cooker, gas hob, electric single oven total cooker rating from the manual is fairly low at 2055 W cooker comes with flex and 13Amp plug to plug into a regular kitchen socket in ring circuit there is a permanent hardwire cooker connector (on its own cooker...

Hi. We have a balcony that forms the roof of the porch of the flat below. * the side balcony wall and side porch walls are one and need repointing. * overflowing pipe was part of problem and was fixed in high summer. * there is currently damp inside the unheated porch with the onset of...

I have an outside balcony that has concrete paving stones effectively forming a basin so that rain water collects and runs off into the drain pipe. There is a bit of damp below the balcony and I want to seal between the stones to eliminate this as a possible source of damp. What grout or mortar...

yes, been weighing things up. System actually works very well, giving instant heat and we dont have to rip the walls etc for pipes. Also wont be living there rest of our lives. I have found that I may be able to get a nearly new JS system thereby reducing costs, which makes it seem reasonable...

Anyone got any idea of what one of these units costs new (Johnson Starley J32 Hispec )? Thats excluding labour. JS wont give any prices unless you are in the trade (im not a qualified gas fitter) and I cannot get any help from their recommended fitters i.e. no idea of labour vs materials costs...