Search results

Problem sorted.......managed to force door open......took lock off of door and just tryed puttin it back on :? :twisted: :lol: Lock is now working better than before! something must have been jamed! Glad i dont need a new lock!

Cheers

Tryed WD40 and still no joy! The three hooks are just not retracting into the door fully! Need to take it apart tomora

Thanks for the reply! i will try that tomorra as i have managed to get it locked tonite! Hopefully i dont need a new lock!

Right! i managed to open the doors and i can see that the hooks (three) do not fully retract into the door when i pull the handle down! - Does this mean i need a new lock? or is there a way to repair!?

trying to fiddle around with the door all night! It appears to lock and unlock fine - it feels as though something is blocking the door from opening! The hinges of this door are on the outside - does anyone have experince of taking this type of door off its hinge. I wana avoid forcing the...

I know a picture would be helpful although i am unable to post one at the moment the lock looks to have an L on it! and the key says LSH

yes plastic

Hey there M y double french doors that open outwards are stuck and i am unable to open them! i am able to move the key to open the lock and it opens the locks at the top an bottom of the door!- although it does not appear to open the main lock in the middle!( i can push the door out and see...

Thanks woody! I was under impression that i had to 'step out' onto a platform?! not sure why i thought that!

Could be low gas pressure in house! Ie fault with the supply Do you still get decent hot water/heating? Do you have a gas hob in your house? and if so what is the flame picture like? You are Otherwise unable to measure pressures as its a job for Gas safe engineer.

New extension- Anyone know what level external ground level has to be below airbricks? (ground level is near level to the height of new airbricks) Also looking for the building regulation regrading a step from a patio door to outside, i am aware that i need to have a step out onto a...

u need a Fan modulation pcb - common fault

Yea thats how i do it

I heat each pipe up indivually about an inch away from fitting, after a little heat move the flame towards the fitting and solder starts to run.

Had a little Experience of code 14 and this was resovled by replacing The White ign box and leads to spark electrode and flame dectection probe.(as recommended by ravenheat tech dept) It sits inside of the combustion chamber and is defo a job for an engineer. Older models have this box...

Your loud bang (and bent combustion chamber) is caused by fan modulating PCB switching your boiler on/off/on/off - This causes a build up of gas in the combustion chamber! Seen this on every single one of this boilers !

Had same problem in past and it was a faulty flow switch!

LOL

yea cheers will get a set! and btw the screws were steel!