Search results

  1. C

    Vaillant EcoTec Plus 428 constant cycling

    Bigger pump is not the answer, to the right of the pump where the expansion etc tees off see if a magnet sticks to the pipe work
  2. C

    Vaillant EcoTec Plus 428 constant cycling

    Can you upload a photo of the pump / valves and the position of the expansion pipe/ cold feed connection
  3. C

    Lining a cast iron gutter with uPVC gutter

    Could it be lined with lead ?
  4. C

    Flush siphon unit / filling valve too big for existing cistern?

    Can you turn the fill valve
  5. C

    Charging expansion vessel

    Ye unless you’re charging set up is leaking
  6. C

    Solderable wall-plate-elbow

    497FH from screwfix ,any good ?
  7. C

    Ceramic disc cartridges kitchen tap

    Yes they normally come in a pair
  8. C

    Hive wiring to ideal logic 30 & underfloor heating?

    One could be made to work
  9. C

    Hive wiring to ideal logic 30 & underfloor heating?

    Yes it can but you would use two hive or similar stats as you would need the under floor to run at different times to radiator circuit..( multizone)
  10. C

    Vaillant VCW GB 221 H Water valve question

    You can buy a full service kit ,personally if a complete new one is available I would replace the full valve.
  11. C

    Heat exchange clean DHW

    Yes that can be done ,
  12. C

    Water leak affecting wooden floor.

    Once you remove the trim round the bottom of the skirting you should be able to see how loose they are , but probably blind nailed or glued.
  13. C

    Rising main, should I convert 15mm to 22mm?

    What pressure/ flow rate have you on the mains? But certainly no down side of running 22
  14. C

    System boiler puzzle

    Have you had the expansion vessel and safety valve checked?
  15. C

    Bathroom ceiling cladding

    whiterock panels might suit
  16. C

    Leaky tap connection to bath

    Most come with a seal to stop this,or slacken the back nut put sealer under the tap and tighten back up.
  17. C

    Heating not turning off

    Danfoss/ Randall 3 port service kit used to be available ,maybe worth a search
  18. C

    Condensation in boiler pressure gauge

    More likely it needs a new gauge.
  19. C

    Help, I’ve got a leak!

    I currently has a rubber seal , it could be replaced with a solvent weld , but it looks like the boss may be showing signs of leaking .
  20. C

    Heating not turning off

    You should be able to turn the brass base spindle by hand, if stiff oil it
Back
Top