Search results

Thanks, it was already set to no. However the Flex unset was set to 1 so I changed that to 0. I probably changed it whilst trying to get the wireless keypad to give me level b as an alternative choice. It seems to work now but got a house full so will try again tonight.

Any help would be appreciated. I've researched previous posts round this but can't figure out where I've gone wrong.

Pyronix Enforcer installed. Downstairs sensors and contacts level AB One landing PIR level A. Enforcer panel is in cupboard upstairs somewhere so using a wireless arming station keypad in the hall. The front door contact final exit. The hall PIR next to it 09 An adjacent room PIR also 09 as it...

Thanks for the advice. The 5 amp vs 0.5 amp my mistake/ bad eyesight. I bought one dome camera, to be mounted off the underside of the porch ceiling , no door, so it should cover entrance and some of front path. The other three are all turret cameras which I planned to mount on vertical walls.

So the power lead is for someone with a different recorder?

Oh... Thanks . Now I feel like an idiot... . At least I didn't buy any bellwire!

And the connection

Camera kit as follows! Hikvision Hiwatch 1-4 camera 4MP

No, the main thing is to create a draught free insulated space in your loft, with the tile space well ventilated as it is now. That way it drys out in the wind etc. But you don't lose as much heat out of your loft. If you don't seal it off you won't get the benefit you are after. You can use...

Hi, I've just bought a hikvision kit, 4 cameras and a recorder. The cameras have a port for an ethernet cable and a short flying lead for the dc supply. I wanted to have all 4 cameras, their power cables and ethernet cables going to one location where the recorder is. The longest run is about...

I think the right way to do it is to make the rafters a bit deeper ( by adding wood) so the insulation has a gap between it and the underside of your roof tiles etc. This is airflow to remove any moisture that gets through.50mm is enough.

No expert and not a plumber/ heating engineer but I think you would have problems bleeding and filling so would need some sort of vent at the high point. The pump on the manifold would have a bigger job due to the extra head and you would need that confirmation from the supplier ( I think).

Alarm now working. Thanks for the help. IO board seems OK after all:,I powered the system down (again) removed panel battery( again) made sure IO board was securely plugged into front of panel and removed the two wires to the bell. Then powered up. No Comms issues. Then powered down, but not...

Thank you very much.

Thank you, that would be appreciated .

Thanks for the help so far. I think I may have a faulty IO board. I'll have one last go at attaching it without any wiring to the bell and see if the system starts normally. One question on the Deltabell WE, can I move the jumper (so the comfort Leds come on) without unplugging the batteries...

No, when I got the system the IO board wasn't connected to the front panel and I set up the system fine but without a bellbox . ( no ladder) The IO board, only has 2 wires to COMmon and 12V+. Thanks.

The reason I ask is when I powered down the Enforcer entirely ( took battery out too) plugged in the IO board in and connected power to the bell and then re installed battery and powered up I got the 485 Comms Lost message.. . Please wait. I gave up waiting after 15 minutes. When I disconnect...

Much appreciated...one more question, do I need to fit the IO board in the Enforcer box to supply power to the deltabell , or is there somewhere else in the Enforcer panel I can come off?

0.2mm^2 I think.