Search results

Had two wallpapers papered today and the pattern doesn’t match. I’m not happy with it but decorator says patterned paper doesn’t join round a corner. ? Opinions please. Ok

All sorted

veritas R8 I put the meter on continuity across the two silver screws in the contact.

Hi all new door contact installed and wired up. Veritas R8 I haven’t fitted the magnet yet but using meter the new door contact is already in a closed circuit position. Have wired using red and black as manual. Any advice.

its buried above the ceiling and run through joists

oh bugger. Think I will look for couplers that plug together rather than butcher the wiring

Will it be similar to aerial cable when cut? Inner and outer wires?

ha no! I did curse a few times. Thanks will buy some of them.

So... Managed to run the cctv cable a few months ago before a room Was plasterboarded. Went to connect the cctv camera and found I had run the cable the wrong way round so i have ended up with the same ends as per photo. is there some type of couple that can connect these together? will need...

Need to cover the flooring gap where it meets the French doors. Prob is we have side panels and the quadrant is to big as shows above glass. is there a flat trim that can be used?

Yeah!

No I have done that and it’s working fine.

No they are all in use

The zone wiring has the global tamper circuit connected

New contact to protect single garage door and also be walk in zone to start the timer. Currently has pir in room which is on walk in zone

I have a cable in place for a new door contact. The cable is coiled up by the control panel. I would like the new contact to be on the same zone as the room pir. Should the cable come out of the control panel terminals for the new contact or the room pir? Does it matter? Thanks

Ah got ya

Zones 1 (hall) and zone 7 (garage) need to be exit/entry zones

I’m getting zone 6 on display but confused as the garage pir is zone 7

garage is zone 7 though?