Search results

I do wonder controller manufacturers only support OpenTherm on combi boilers…?

Would this be the same with Tado and Nest?

Only a mid-terrace town house, 1x Zone for Ground Floor CH, 1x Zone for 1st and 2nd Floor CH and 1x Zone for HW.

I was looking at the Wiser but seems it only supports OpenTherm on a combi with one channel. I have a heat only and three zone. Anyone been able to get OT to work with the wiser with more than one zone?

As I have three zones, would I need to buy three sensocomforts?

SensoComfort is bloody expensive

My house is 10 years old and only has the Honeywell on/off setup. I was thinking of going with a Tado with OpenTherm. Are the savings which I am going to gain worth investing in an OpenTherm thermostat on a well installed house?

Any views on installing modulation controls on a new build, well installed home?

Glad I came across this thread. I am looking to go with either a Intergas or Vaillant boiler and based on support the latter is becoming my preferred choice. Do you know if its possible once we have the data from the eBus connect this the board to a OpenTherm controller, like Tado, EPH or Netatmo?

Intergas technical support, well one person, also mention getting the Xclusive instead of the Open Vent, but it would then mean removing the pump etc... from the airing cupboard and have it all in the boiler and then a single point of failure. Doesn't really sit right with me... The modulation...

Intergas say to maintain the warranty I need to service the boiler every year, would the front plate seal and 4 year service kit not be included and covered under the annual service? Problem is difficult to have a OpenTherm, well known make boiler which is also 650max in height as mine...

Have you had any problems with the Open Vent system? How have you found their support?

Heat exchange is leaking, many people have said not worth replacing due to a crack.

Hello, I live in a mid-terrace house which is 10 years old near West London. Our boiler needs replacing which is a Pottertron SL 15 on a S Plan system. The boiler is on the ground floor with the control/tank/expansion vessel, on the 3rd floor, we live in a townhouse. Number of local engineers...

Hi, My three way has started to leak and I have noticed this is related to the water filter tap section. I've looked online and seems I need to replace the cartridge which goes on the side. However, I have no idea where this tap is from or who its manufactured by as it was installed before we...

Hello, I have a Kingspan thermal solar system, which when operational sounds like it has air bubbles. I did notice low pressure, however this was caused by a faulty valve cap which I have replaced, after I pumped up the pressure vessel. I have attached pictures showing my system. Can anybody...

Hello, Our house is five years old and we have an external wall which on the other side is the garage. I would like to hang 1x 1000m and 1x 400m kitchen units on the wall, however, the plaster board is 70mm deep with insulation. I am concerned on hanging the units directly on plasterboard...

Lowster, what does it say on the tin for fresh plaster?

Thanks, I assume this is something which would go over the mist coat? Removing the mist coat in the ceiling is going to be a pain.

Hello, Did you manage to resolve the chalkiness, as I have the same problem which is too large to now go and remove the mist coat? Many thanks.