Search results

As long I get an acceptable slope angle with a eave 3,500mm I will tell him to do that.

This is what he told me if I what 2.4 high ceiling, but I think according to my drawing and sise of the garage (to scale), flat ceiling can be achieved Please your comments are much apreciated and wont be upset if you tell me I'm wrong, I just want to get what I want if feasable Thank you again

Max eave allowed id 3500 high Will I get this as you commented above Thank you for your reply

I have a builder who is building a garage for me, its a 2 skin walls 5 metres wide 6 mtres long and 3.5m eaves. He is insisting that I can not get a 2.4 mtres ceiling hight due to the angle being just below 19 degree. Can anyone please comment on this also I have attached a trawing That I just...

only shows "welcome back john " when I set for exit !!

I had this system fitted last year replacing my existing premier 88. My query is when i set the alarm i get a text banner displaying "WELCOME JOHN" and I do get the same message when coming home disarming the alarm. I when through the installation manual and user manual and can not find any...

Its because I found one in my draw and wanted to install it but it will not work on V3 but will skip it now and will go for an Elite panel with SmartCom

So , my existing keypads are Ver7 add2 and Ver3 add1 If i got it right and decide to replace my existing panel with Elite version I would need to replace my keypads to Ver 10. What about the existing Expanders, are they ok

OK, you might be right that I have a Premier 88, so if I understand right if I replace it with an Elite version ,does it have to be programmed from scratch or data from old panel can be uploaded to new one Also it might sound silly, but will existing remote keypads be compatible. Thanks

Thanks for your input, but the problem still is firmware update of the control panel in which I believe mine is in V3 and smartcom need V4. I do have Wintex software to read and programm the pannel but to flash the new firmware is a bit complex and sometime can corrupt panel. OK , by pressing...

Hi I’m looking for an experienced Texecom engineer to program and help me understand my installed Texecom 48 Premier Elite Series. Fitted to it are 2 Expander 8XP, two keypads, . All of which I are configurated but i want to fit a Com Wi-Fi CEK-0002 to it. Ill also wont to use the phone APPs...

- to panel + to extenders and keypads

Sorted It was faulty battery. but still have the Wintex connection problem !!

Fused spur socket

Ok Just fitted 2 new yusa bat and disconnected mains and yes the alarm stayed silent So I m going to find out if one or both are faulty and return them to supplier Thanks Europlex

13.5 volts

Ok Well these are 2 new battery fitted about s month ago I just received 2 new yusa battery last week I will fit them is the system an will report back Thanks

There is a battery inside the panel and is fully charged also the system has an additional power supply with a fully charged battery Both at 13,8 volt The pcb has 4 fuses and all are ok If I press the batt kick start sw while there is no mains connected, the panel is back alive but only if the...

I just have noticed that If I disconnect the main supply I get full alarm, keypad are disable and the only way to stop is to connect supply and access code , the batteries (2) have been replaced a month ago and are in good health. so the pannel is working on main supply, have checked all fuses...

Ok... more problems, I just have noticed that If I disconnect the main supply I get full alarm, keypad are disable and the only to stop is to connect supply and access code , the batteries (2) have been replaced a month ago and are in good health. so the pannel is working on main supply, have...