Search results

Sorry for the delay replying The car is well serviced re: plugs oil filters My thinking is there will still be a sensor issue after the exhaust is repaired AFAIK exhaust leaks won't cause high CO and HC only lambda

Hi My car (99colt) failed on emissions and has a couple of exhaust leaks Is it possible the exhaust leaks could cause the high CO( 7.24% high idle) and HC( 1546ppm high idle) or will it definitely need more work Thanks

i figured out the problem with the AWO 10761-it's the controller board i stuck it in the oven and it's back working temporarily until i get it replaced still looking for assistance with F26 error -nearly all the lights on the dashboard are also iluminated

Thanks I did prise it out before I asked the question I noticed the shaft was slightly damaged in the process Maybe the wd-40 would have helped?

thanks are you sure?

Hi guys Hoping to replace a timer and not sure how to remove the front knob? model is whirlpool awod6727,im sure there's a trick to it before i go at it? thanks

Hi guys,i have 2 whirlpool washing machines and they're both giving trouble 1st model is AWOD 6727- it originally wouldn't start so i put it into test mode and it stopped on error F13 which seems to be door interlock.I bypassed this for test purposes and it's now displaying F26 and still won't...

i opened the door interlock with a screwdriver and it seems to have righted itself now just a new seal needed and it may be ok thanks fidom

i gave it a trial run-machine seems to be working just 1 problem -the door is now permanently locked closed even with the machine unplugged the door open light illuminates at end of cycle but it's still locked?? the only change in electrics was the wash motor

not good practice anyhow not familiar with bs7671 but i would be surprised if its permitted it's certainly not allowed here

hi fidom yes drum bearings worn yes the motor plugs are interchangeable the reason i swapped drum and motor is because the replacement drum is slightly different and the original motor from the 6202 won't bolt onto it unfortunately i don't have an identical replacement drum to work...

hi i'm working on another family members machine this time the machine is a awo/d 6202 with worn bearings i have a drum+motor from a awo/d 4305 which i have transplanted however the motors are different .the 6202 is a 350watt with 7-pin connector and the 4305 is a 380 watt with...

all seems well but i stopped it before end of cycle i mixed up the belts one seems a little loose so i fited the other one but i want to be sure thanks again fidom

thanks turns out they were different models 10561 10761 motors different mountings timer and door switch are identical

ok thanks fidom il do some tests and comparisons on the motors they're 7-pin would that indicate split field coil? i'm reading tacho 131 ohm,armature 4 ohm and field coil 1.3 ohm IR for field and armature ok i may not test motor as i figure it's one throw of the dice for me anyhow

hi i've fitted a replacement timer i inadvertently turned the dial on the timer before refitting the cams back in their original postion is there a procedure for syncing the cams back with the timer itself or does it matter if there's been an adjustment made on the timer if you...

great thanks