Search results

  1. K

    New wiring regulations

    Hi, I've always done my own house electrics but now the new regulations have come in I'm not a hundred percent sure what i can and can't do. I want to add to a existing ring main extending it around a conservatory is this allowed? I believe i can add to existing circuits but not make new is...
  2. K

    run off water connected to soil drain

    Not sure what forum was best for this. Just having conservatory built. It is being built right on the edge of my property so the guttering drop has had to be removed they are going to make this link ito the guttering of the conservatory and run down to the end where it will then go down into...
  3. K

    Advice on microbore

    Was going to fit thermosat to protect from frost so would of thought it should be ok with central heating extention.
  4. K

    Advice on microbore

    just been trying to work it out found out the following e-glass =1.6 floor =0.6 roof 25mm poly carb =1.4 cavity wall =1.5 (don't know if that is cavity wall insulation or not) size = 4x3.5x2.1=29.4m3 there is roof peak on this but to keep it simple left that out total wall...
  5. K

    choosing radiators

    Hello again I have chosen 2 radiators which add up to the required output that i think i require 3k. The spec sheet says "outputs at operating temperature 75/65/20C" I've just noticed a temperature table which states that factors are for difference between water temp and room temp 5C is 0.05...
  6. K

    Advice on microbore

    Hi all. I am currently having a conservatory built. It will be 4x3.5x2.9 to the peak. I have worked out that the heating that i require will be 2.6 to 3KW can any one confirm that this will be ok. one wall solid (with small windows on top) the other two glass with dwarf walls and a polycarb...
  7. K

    consumer unit tails

    I'm looking at replacing the old fused type consumer unit with a new type. Is it is posible to break the seal on the board fuse to isolate the supply? If not how do electricians install new units? Is it possible to inform the board then remove the fuse your self?
Back
Top