Search results

Hi, Need to get my bath sorted, the enamel has worn off and need to get it fixed. Had a guy round and said it would be cheaper to re-enamel it rather than replace the bath as it is sunk into the wall by about and inch and would involve a lot of work to replace. Has anyone had this done...

... cheers dude, thats what i had planned.

.... When I removed the T&G wood from the ceiling (downstairs hall, stair well and upstairs landing) I found above that was artex and had 3 big holes in the artex so thought a new sheet would be best for that. The walls where pretty rough and are going to need re-wired as well to...

Hi, We are re-decorating our hall and was wondering if it is ok to just tear down the existing plaster board rather than strip the wallpaper off and put up new plaster board? Cheers Rezarf

Hi, We are re-decorating our hall and need to remove 2 radiators but they do not have the valves on them to shut of the water to them like my other radiators. How do I go about removing them without water going everywhere? Also one of the radiators has no TRV on it as it is always on...

nearly all done, filled in the gaps with the foam, the gaps were shocking, will need to at some point get new windows and repair the damaged areas around the widow as previous installation looks like they threw them up and thought forget about these massive gaps and loose rubble. Got all the...

finally all done got the floor as level as i could due to other problems with installation of electrical wire and copper pipes. Thanks god I could get an electric planer. Rezarf

so i'm going to just use a planer to level the timber on top of the steel beam, Should remove the nails before planing? or just hammer them down?

Hi, We are currently re-decorating our bedroom and i am going to white gloss my window frame. I took some of the frame off and had a look and noticed that i could see some day light peaking through. Should i re-seal the outside and fill in the other internal gaps with...

took the carpet up for a closer look and lifted some floor boards. the wood on top of the beam is there to make up height but it is too thick and has 2 floor boards joined over the top of it causing it to be uneven. No idea what the steel beam is for but it has the floor joists...

The walls run opposite the joists. The more i think about it probably. I think the main part of the floor which is bad is above the steel beam where it is raised and bevelled, i think this is because the steel beam has a piece of wood on top of it and it is too thick causing the raised floor...

Hi, think i will just try and fix the uneven board rather than replace the entire floor So we are redecorating our bedroom and we are going to replace the floor and insulate the pipes while we can. T&G floor boards are down just now and i was going to replace it all with chipboard...