Search results

  1. J

    Change Honeywell BDR91 receiver to Hive, wiring question

    Hi, My boiler is the Worcester Bosch Greenstar CDi 29 Classic which is installed in the loft. It has the Honeywell BDR91 Wireless Relay Box located between the boiler and the fused spur. The programmable wireless room thermostat, CENTER EHE0200361 RF is in the hallway. I want to replace this...
  2. J

    Wrong felt

    I recently purchased a roll of roof pro torch-on roofing felt underlay from Screwfix by mistake, I meant to buy roof pro torch-on roofing felt cap sheet, both the same price £66.99, just clicked on the wrong item. Anyway, I only realised the mistake after I came to installi and had cut the first...
  3. J

    Bath jet holes plugs

    I have a bath with a jet system fitted which is never used. Given that the bath is in as new condition was thinking of removing the motor and pipes rather than renewing the bath. The obvious snag of course is how to seal the holes. Is anyone aware of an available product such as white plastic...
  4. J

    Extending from SWA

    Hi. I have 4mm SWA coming into my garage connected to a small plastic garage CU. The CU is located in a really awkward vulnerable position at a low level, the access cover of the CU has already been damaged. It's my intention to raise it to a higher safer position. I have purchased a...
  5. J

    Yale external siren

    Hi I have the yale mains powered external siren. The instructions state that there is no need to change batteries as it has a built-in battery, and with the 12v dc supply connected the battery is disabled and the on off switch has no function. Does this mean that there is an additional...
  6. J

    Fused spur location

    I have a question regarding a 13 amp fused spur of a radial circuit that is spured from the 32 amp mcb of the final ring circuit. Can the fused spur be located at an accessible point in the loft rather than the bedroom. Is this permissible or does it need to be accessible in the room?
  7. J

    Cable Rating

    I currently have a radial circuit from the house to the garage consumer unit. It feeds a single socket and the lighting. As it's only 1.5mm and I want to add more sockets, I'm considering adding a second radial. Looking at the existing 1.5mm installation, a twin and earth runs from the house...
  8. J

    Horizontal Cable

    I have a question relating to the cabling that is behind the built-in oven. Would it be permissible to run the feed 6mm cable from the point of entry beneath the worktop horizontally if it is surface mounted within a plastic trunking?
Back
Top