Search results

Hi Thanks for the advice, we will do that. Thanks again for all your help it is really appreciated. I'll keep you posted on how we get on. Claire

Hi Thats great, we don't have a multimeter but will invest in one as cheaper than getting somebody out!! How do we do that check is it simple and if it is the stat, is it something we can change ourselves quite easily? I have just twiddled the stat again and it is not clicking now...

Hi Not really sure but there are 2 valves - how do I tell? The first looks like it is on the central heating bit is a SZM 1802 and TS93 and the second down by the cold inlet is a SZM1803 and TS93 but they both have just a 1 pipe going in each end (not 3 - none going in the bottom) if this...

Hi We have got a Tribune HE Unvented cylinder with a dual thermostat model TS207 (looked this up on range website) We have a Sunvic programmer and a gloworm gas fired boiler. www.range-cylinders.co.uk/pdfs/technical/tribune.pdf We basically have the set up in our airing cupboard as...

Hi John Thanks that is a great help. I think we will do some investigations before we replace anything. Any clues to how we go about testing the individual components and which ones are likely to be the culprit? Thanks again Claire

Hi John Thanks for your reply. The electric immersion is on and your right it is heating up. However, I am a bit confused now as I just turned the thermostat dial (the one on the heating system on the front of the cylinder not the electric immersion) and it is now clicking at about the...

On getting home yesterday we found our central heating / hot water programmer had fused. The fuse was replaced and is now working. However, since this has gone we cannot get the hot water cylinder to heat the water. We think it may be the thermostat (Range dual thermostat TS207) this does...

Hi Yes I got it sorted, the guy came this morning and just changed the programmer for a new one and it is still working now so it seems it was that. They are really easy to change they just unscrew from the bottom and clip of the back plate. B&Q sell them for about £35 We will have to...

Anybody got any advice on what could be the problem?

Thanks for your reply The instructions say they do have a battery, however the light is on and it goes off when we switch the power off at the wall, so would it be the battery? ( we didn't fit the programmer ourselves and don't really want to take it off) The engineer who came to fix it...

Hi I am hoping you can help me. I have a Sunvic 207XL programmer which has been installed for about 1 and 1/2 years and working from new no problem, however last week the LCD display went blank, it did not appear to be the power supply as the backlight was on and the on/off switch on the...