Search results

Obtaining the replacement LED card took quite a while and I've only just fitted it. The machine has not yet completed a full cycle but the On/Off button now works and repeated depressions of the P button steps through all the available wash options. Many thanks rocks1! Davros

Many thanks rocks1. I've got a replacement LED Card on order. Davros

My DIF04UK dishwasher has developed a fault whereby pressing the On/Off button has no effect on the appliance. I've dismantled the door and checked the visible wiring, eg for breakages around the door hinge area and in the vicinity of the retaining bar but can't find a problem here...

Hi Leccy, Many thanks for that very useful description of the basic functionality of single compressor fridge/freezers. My Bosch KGV28V00GB/01 fridge/freezer seems to fit the first case you described, ie evaporator plate and single thermostat setting control in fridge, and separate...

Hi Leccy, I worked through the check list you kindly provided and am embarrassed to say that what I found was a large build up of ice along the pipework at the top/rear of the freezer, particularly so where one of the pipes enters the freezer compartment. My only lame excuse is that being...

Thanks for your response Leccy and for the pointers that you've given me to check. I'll follow up on these. In the meantime though, that "pop out cover" must be hiding something as I haven't found any screw at the lamp holder end. So at the end nearest the door, how does one pop the small...

My 5 year old Bosch ClassiXX Fridge/Freezer KGV28V00GB/01 has developed a fault whereby it runs but stops prematurely before the required temperature drop has been achieved. I strongly suspect that the temperature regulator needs to be replaced but I can't see how to remove its plastic...

Yes, I followed Technotim's advice as above.

Agile, ChrisR, and Technotim, Many thanks for your collective responses that so fully explained the ceramic valve replacement problems as experienced by the trade. As a mere amateur, its no wonder that I was having difficulty in locating new valves for my Aquadisc 2 tap. The main thing...

Hi Technotim, Many thanks for the most useful info. I've been on the Leisure/Rangemaster web site before but obviously not investigated it thoroughly enough as I've not previously come across the Contacts page for which you've provided the url. Interestingly, the web site still lists...

Thanks muggles but........ from the experience of trying a few of my local plumbers merchants, the implication of your answer seems to be that obtaining ceramic valve cartridges that fit in all respects is a matter of experience or "hope and poke". None of my local merchants had valves that...

Does anyone know from where I can obtain replacement ceramic valve cartridges for an old Leisure Aquadisc 2 kitchen mixer tap? I've looked at the ceramic valves at "notjusttaps.co.uk" and the very large selection at "lunns.net/tapspares", but neither appear to offer exact replacement valves...

Hi Jack, You were absolutely right about the cause of the slow-to-start/no-start problem with my Hotpoint WM52P. Got the replacement door interlock today and after fitting it all was well with the machine. Out of interest, I took the old door interlock (a Tip ZV-445) apart. I hadn't...

Thanks for the info Jack. Focussing on your suggestion of the problem being within the door interlock component, I tried the following test. With the door deliberately left open, I set a program, switched the machine on and then closed the door firmly. To my surprise the machine then...

Our WM52 has developed a strange problem the logic of which defeats me! It typically takes 10-20 seconds after switching it on before it actually starts, and during this initial "dead" period it just sits there in total silence and with the "Door Locked" indicator unlit. Nevertheless, once...