Search results

That's the cookie!! thanks I now have it wired as :- COMMON to terminal 4 ON to terminal 5 OFF is not connected this seems to be working fine now, thanks for all your help. J

I've connected 2 > 4 & 3 > 5 as you said but where do I connect the COMMON to the W/C? The room stat isn't operating the heating with just these two wires connected. thanks J

Thanks for your reply but I'm a little confused by that? The room stat is a battery powered digistat with the instructions shown in my 1st post. Where exactly do I wire the ON , OFF & Common wires into the wiring centre? thanks again :)

I'm replacing my useless and unreliable RF room stat with a wired one. I know which 2 terminals are call & satisfied in the wiring center but do I simply connect the COMMON to the live terminal in the wiring center? The "digistat" simply says in the manual 1 - COMMON 2 - ON 3 - OFF...

That's done the trick!! :D You're a star! thank you very much *** If I can help you some time, feel free to ask. I'm a precision engineer and web programmer if you ever need help in either field.. Cheers!

OK, I'll do that now.. I DO appreciate your time and help :D

OK, this is what I had done. with the LINK (on salus) still in place: Live from T1 to live on salus N from T2 to N on salus SL(ON) going to T5 and SL(OFF) going to T4

Looking at the SALUS manual, I wired it according to the 230V switching method and NOT the one below it, the volt free method! Should I wire it using the volt free method?

T4 (on junction block) is from terminal 3 on programmer T5 (on junction block) is white wire going to the MV OK, I'll re-write what I should have in the 1st place: Using terminal 2 for the common. PROGRAMMER SET TO OFF & STAT NOT CALLING: (T4)=240V - (T4) = 0V PROGRAMMER SET TO...

Sorry, yes I meant terminals 4 & 5. So You want me to remove the WHITE wire to see if the reading is still 156V right? I'll do that now.

If it helps you understand this any better, I've used the wiring diag on page 4 (top one) of the SALUS manual as linked in my original post. thanks

Thanks for your replies, this is readings I have taken: Using terminal 2 for the common. PROGRAMMER SET TO OFF & STAT NOT CALLING: (T3)=240V - (T4) = 0V PROGRAMMER SET TO CON & STAT NOT CALLING: (T3)=240V - (T4) =0V PROGRAMMER SET TO OFF & STAT IS CALLING: (T3)= 156V - (T4) = 240V...

Let me add some more info. As above, I've given the receiver power from terminals 1 & 2. Terminal 3 & 4 were linked together, I'm assuming this was to override the fact that there was no room stat? I have taken out the loop and put the ON & OFF wiress from receiver to these 2 terminals...

I have tapped the (L) & (N) to terminals 1 & 2 on the wiring block.

Hi. Is there anyone on here willing to help me with a small problem? What it is, I have recently moved to a new house with CH but there isn't a room stat to control the heat, only a programmer (ST699P). The heating system is a Baxi (back boiler) with the following wiring layout (minus the...

just pics