Search results

Hope someone could help with an issue ive got with a new power shower? I have a lower pressure, gravity fed system and have recently replaced the power shower and also am just about to install a 2nd shower in other bathroom...I have made the entire house high pressure by bypassing everything...

Hi all, hoping someone can give me some advice on sealing a Marble Sink we have just fitted? We have some QEP Tile sealer which is from B&Q; would this be suitable? It says it can be used on Marble, along with other natural products like travertine, slate, limestone, terracotta etc Any...

Hi, I hope someone can help? I have an immersion heater that, if it is left on for more than 45mins, will start to boil the water in the header tank in the loft! So, I have to time how long to have the heater on and then switch it off manually or have the oil central heating on but thats a...

HI all, I just bought some quater shere uplighter wall fittings from wickes. They are max 60W single bulb. I have just removed some metal light fittings to replace with these new ceramic ones but noticed the new ceramic fittings do NOT have an earth point. Im guessing because they are...

Hi, I have just ripped out some old worktops and replaced with new and at the same time decided to replace the sink, oven & hobs. The hobs sat on top of the worktop and the oven was seated into the unit below. They were both hardwired into a point at the back of the oven on the wall. That...

Hi, I havent been living in this house for long. I have just found what appears to be an outside garden tap but it didnt have a handle on it - this could have just been lost. When I opened the valve/tap with a spanner a load of gunk splurted out, then it cleared and now its warm/hot water, the...

Hi everyone! Im a complete newbie to the world of plumbing and oil burners apart from spending a lot of money getting my one fixed over the years. I have a trianco tro 12/14 boiler that wont fire. I thought we had run out of oil ( I knew it was getting low but I have been busy rebuilding a...