Search results

Hi, I changed an old 3 way light switch in the hall way. It controls 2 lights in the hallway and 1 on the landing. The landing light now will not turn off. If I disconnect from the 3 way switch and just use one of the 2 single switches on the landing it works fine. Sorry for the bad...

I don't mind resetting it as it is useless at the moment. How do I reset it?

So the engineers code of 03 is no use?.

Hi, It says engineers code is 03. Does that help?

Hi, I have moved into a new property which is fitted with a Scantronic 9800+ alarm. All I have is the manual and no codes etc. The alarm has power and the sensors seem to be working, but I have no idea what the code is. Is there a way that I can reset it and to find out the pin code...

I have installed a kitchen with granite worktops and now finish off the worktops by 'covering' the join between them. Is there a paste or something similar which i can use to do this. Thanks.

right, so i need one of those things you put a picutre of and place that at the top of the cylinder, yes? then hopefully it will only pull in water and this will push all the air out of the system?

kevplumb.... where is it then? and what is the point of one of these items that goes in the top of the cylinder? and seco services said to run the pump off the surrey flange?? what is that compared to the top of the cylinder??

is there anything i can do now to make sure the tank is full and no air is in there.

guys, should i be having one of those fitted to my cylinder @ the top?

onetap. not sure, on capacity, i would say over 100 litres. cold should fill up as and when needed. cylinder is probably 4 foot below the tank. the hotwater has something strapped to the side which shows 45 c no flange at the top of the storage cylinder.

karl... i believe the top of the cylinder. the ensuite is new but the bathroom has been refurbed and a pump fitted 2 years ago.

and yes one pump is connected to the cylinder and the other is connected to the water pipes that go to my main bathroom shower.

sorry karl, i am not sure what you mean. amateur plumber here....;->

the hot water tank is 114 litres. it used to work ok and even with a full tank it will happen very quickly.

I am hoping someone here can help me! I seem to have air in my hot water system somewhere. It really causes a problem when using one of our power showers. The water dies and the motors start screaming as it struggles to get hot water. We have a traditional vented system with a header tank...