Search results

Can anyone identify this water heater. Thanks

can anybody ID this valve for me as it needs a new cartridge Thanks Its the chrome one with the riser attached

Can anybody tell me what type of shower this is as i need a new cartridge. Tim

I have a customer with an internal toilet fitted to a 1.5m SVP with an air admittance valve on top ,the push on type with a rubber boot and not solvent welded. The trouble is the pan keeps backing up but when i remove the rubber boot or the valve the pan clears . Is there anything on the...

I have a impey wetroom tray and need to lay my heat mat over the floor including the wetroom tray..I then intend tiling it with mosaics. I need to cover the heat mat prior to tiling obtaining a flat surface. As i cant use self leveling because it will run down the tray,can anyone suggest a...

Just fitted new cylinder heating up ok but the hot tap is very powerfull and eratic 3.5 bar coming in to house 3 bar prv on side of tank 3 bar expansion vessel any suggestions welcome

THANKS EVERYONE FOR YOUR INPUT I FITTED A CHECK VALVE BETWEEN THE S FLANGE AND THE PUMP ON THE HOT SIDE AND THAT FIXED THE PROBLEM. TIM

w/machine does have 2 hoses and if i fit check valves will that not inhibit the flow to the pump. Tim

Thanks Dan The other hot taps dont start the pump its just the thud of the w/machine demand that starts it, and the flexi,s with iso,s are fitted but a check valve was not supplied in the kit Salamander RSP50 Tim

The hot does have a dedicated supply from the S flange

I have installed a shower pump with a Surrey Flange for the hot and a dedicated supply for the cold and it works fine ,but when the washing machine calls for hot water the pump starts. Could you give possible reasons and solutions for this problem. Thanks Tim

Is there such a thing as a customer of mine has limited space Thanks Tim

thanks kev bit tight changing the diaphram but worked fine on completion thanks for your help. tim :lol:

how hard is it to fit an essex flange with a 22mm draw off. what size hole saws are required and how to deal with the insulation on the tank thanks tim

not if you run a traffic

sounds to me you need to dot and dab .Plaster board adhesive in 6 lge bads on a 6x3 sheet then stick it to the brick wall level as you go and tile next day on a flat wall.

thanks Kev is the diaphram inside the group set tim