Search results

I need some advise, due to problems with my combi boiler i would like to install a back up system for hot water and i thought about an immersion heater. It's something i'd like to tackle myself and i wondered whether or not this is possible? If so could anyone advise on which immersion heater to...

This song was inspired by my glow worm combi boiler e100. here we go.... pedanctivman i'm not happy(do do do do) in fact i've got the blues(do do do do) cause i could have had hot water...

Hi, i am attempting to fit a door seal or door seal gasket. The seal is approx 5ft in length and then a smaller strip approx 10inches long and not as thick as the longer strip. The oven itself has several screws on the front part which i removed to ease out the old seal. What i need to know is...

I would like to replace the diaphragm on my glow worm boiler. However i am having trouble removing the 4 hexagon screws on the cover. The size that seems to fit the best is 7/64" (but it may be metric?) I'm not sure. It feels as if they are going to round off. Anybody got a good way of removing...

Hi, i replaced the motor brushes as it would not spin, since replacing brushes it spins ok but the clothes are very damp? so damp you could wring them out, any ideas?

Hi, i own a hotpoint 9573 electronic 800 super. It goes through all the cycles except the spin cycle it's an old machine but it's been a good one. Anybody know why it's stopped spinning?

glow worm compact e100. boiler not igniting all lights come on "power on" "central heating demand" but burner ignited nothing. I had the incident yesterday with water going everywhere but it seems to have dried out ok and everything( except the boiler ignited) seems fine. Any ideas?

I have a glow worm compact e100 combi boiler.(lucky me) I had been having problems with hot water, somebody told me to check the thermistor, i turned electric supply of but forgot to isolate water. When i removed the thermistor water went everywhere. I mopped most of it up and tried to dry...

Having trouble getting hot water. About 5 months ago replaced diaphragm for hot water. (After receiving good advice from this site.)Hot water worked great for a month or so.Pressure seems ok, i get hot water when i run bathroom tap but when i run kitchen tap at variying speeds boiler not firing...

glow worm compact e100 isolated boiler, drained boiler leaving valve open bar pressure dropped to zero. removed cap on expansion vessel put pressure gauge on nothing registered pumped air in using footpump pumped up to 1 bar pressure dropped to zero. i find locating footpump difficult due to...

I have a glow worm compact 100e which i am having pressure problems with. I have been told the problem is the expansion vessel. The boiler is only 5 years old and has recently had a new diaphragm fitted on the water side. I replaced the diaphragm and would like to tackle the expansion vessel...

I have a glow worm compact 100e combination boiler. Everything runs fine until i put the central heating on, or rather turn it off!! As the system cools down the pressure drops to zero. Sometimes boiler lockout light comes on. I re-pressurize it to 1.5 bar. Everything ok no loss of pressure...