Search results

Cheers. Hope I make it to the shop in time!!!

I'll just hope they are 22mm then, they might well be. I have used push fit before, the copper type with metal grab rings. The ones that stay fixed on.

Do screwfix do 22mm - 3/4" reducers?

ok no probs!! looks like i'll need a compression flexy and 3/4" olive or a reducer fitting or 2, end feed.

I have a 3/4" (22mm)flexy tap connector, push fit type (left in box in shed) Will this be of any good, if the old pipe was imperial??

Thanks for helping. In Screwfix when looking through all the fittings, lots of pages, there isn't a 3/4"-22mm reducer in sight!! Do I need to go to a plumbers merchant? About flexy's - I have heard this can burst, under mains pressure?? Is this true?

Hi Yes high pressure cold, hot is from tank/cylinder. The water looks like it's coming from the elbow (22mm) end-feed type, but it could be running down. Is this common for old pipes/taps. Taps are about 10 years old or more, pipes were original when new suite fitted, so about 40+...

Have a small leak on a mains fed pipe to the bath (22mm) - but the pipe is old (over 40 years I would say) so would be imperial size. It is an elbow fitting that is where the drip is from. A solder-end feed type. Is this usual or rare? The cold pipe is fed from the mains. Would I be...

Yes just got some of the panel off and some water is there on the floor. Have turned the main stopcock off and the water from the bath and kitchen cold tap has stopped immediately. The bath panel is not screwed on and is going to have to be mashed to get off, so will do that now. Is it...

I have a few probs that I'd like some help wit if possible please? Firstly, there's a noise (like hissing) coming from my cold bath tap (under the bath panel), the tap when on is stiff, but the noise stops, but when closed, the sound begins again. WHat could be causing this. It has started...