Search results

Hi Folks Got a Balmoral that fires up and heats up to a certain degree, nothing like it used to, then just keeps switching itself on and off every few seconds. The pump is running and all rads are getting warm. Any ideas? Thanks

Hello all I just fitted a new bathroom and had to do some pipe work near the hot water tank. I must have moved the inlet pipe somehow and now water is very slightly seeping through the tank wall, not from a joint, but through the tank wall about an inch above the inlet. Beside changing the...

Hello All can you still buy the above or new model? I have done a search online for Main and Main Medway without any luck. A search in forum only returns 1 result. Any help would be appreciated. Nobby

Hi Folks where can I buy spares on-line for Teba cookers? Thanks :roll:

I have just been looking at the difference between TN-S and TN-C-S. If the supplier uses the neutral as the earth with the TN-C-S system then why isnt this used with all installations instead of using a separate earth with TN-S or an earth rod with TT ? After all neutral goes to ground anyway...

Hi Folks My Sister just bought a house and it needs loads of work doing to it, new roof, windows, plumbing, central heating, rewire and so. Its one job at a time as she needs to save for each one and it’s a matter of prioritising. Windows and central heating are her first priority as it will...

Hello peeps I just ordered a DIY lean-to/ conservatory from Wicks and was planning to put it on a concrete raft. It has full length wall panels so will not require a dwarf wall. The base will be 3155mm x 2715mm and a depth of 200mm and will have 9mm mesh wire reinforcement. I am hoping I can...

Is it normal for an immersion heater switch to flash inside when it is switched on and off? I have checked the terminals for tightness and they seem ok. I am thinking of replacing the switch with a new one and have been told that I should replace it with a switched spur instead of a 20amp...

Hi Folks I'm looking for a second opinion The boiler was working fine and just stopped. The pump runs, the boiler has a permanent live and a switched live when calling for heat. The pilot light is lit and the gas valve has 240V when set on high or low demand but the boiler doesn't fire up...