Search results

I've just added a new radiator in the utility and its working well but when I revealed the 22mm feed and return to tee into (15mm), it became apparent that they come down from the boiler upstairs and the ground floor rads are teed off in one 15mm loop and then proceed to go upstairs in 15mm to...

Hi folks, I need to replace my internal stop tap and was wondering if it would be ok to use one of these http://www.screwfix.com/p/pegler-ball-valve-blue-15mm/11085?_requestid=1683919 or should it be one of these? http://www.screwfix.com/p/pegler-stop-tap-15mm/15440?_requestid=1684266 or...

I'm adding a radiator in the utility room as it currently doesn't have one (its the end of the garage!) and I can tee into the 22mm feed and return pipes with 15mm and I was thinking of using plastic barrier pipe but I've read that mice could be a problem (it'll be under the ground floor...

Well my old 24v Bosch combi drill just died so I'm after a replacement, its for moderate DIYing so looking at around the £100-£140 mark, considering the Bosch GSB 19-2-Li on offer at Screwfix or the Stanley Fatmax on offer at Argos are either of these ok or am I barking up the wrong tree...

Hi, just purchased a 10m hose with 1/4bsp ends for my compressor and to go with it, I aquired a male and female quick release coupling to suit the 1/4 bsp ends on the hose. All fitted nicely until I came to connect the hose to the compressor.... male into compressor outlet fits but not as the...

Hi, I've just been trying to get my bar shower mixer to stop leaking and when I replaced it on the 3/4" inlet stubs, one of the fibre washers failed and I had a leak! I had a root about in the garage and found an o-ring the same size and it seems to have done the job. My question is, can I...