Search results

Hi all Many thanks for your advice and clarification re regs around this issue. Can now assure myself hob installation will be compliant with part P. Since cable will be in the safe zone, I will use plastic trunking for the cable. Mike

Hi all Thanks for your responses and I can proceed confidently against current regs (and their clarification). Re 'co located' - I mean the 10mm joint connection box and CCU will be in close proximity but physically separate.

Hi To clarify, I mean a c50mm deep box, fully accessible with jointing inside, co-located to the CCU The box will not be 'buried'. Proposed jointing using 60A terminal strip. From your reply John this will be an acceptable solution. The buried cable (from legacy tail and to DP isolator switch...

Many thanks for your helpful and informative replies. DP switch will be fitted at an accessible point in bespoke fitted kitchen (within next 2 weeks). Current legacy termination provides inadequate tail length of the cable given regulations. So, fitting tails directly to DP switch not...

Hi I am connecting a new electric hob as part pf a kitchen refurb. There is an existing 10mm cable which needs to be extended via a 45A isolator switch and CCU to the hob itself (<1metre). I know I can install a 60A connection box which is plastic and surface mounted but would prefer to sink...

Yip. Alarm now works fine using default P1 Program with zones you confirmed having re-setted panel. MAny thanks.javascript:emoticon(':)')

Hi Yes, but you can also (according to instructions) toggle status using Zone identifier. Eg If Zone 2 you can set /unset by pressing the '2' key OR you can use SET as suggested) I have tried both. Perhaps I need to try a factory reset and try again in case logic is a bit messed up...

Hi Thanks for reply. No joy unfortunately. I did try to allocate all zone detectors to P1 thats when my problems start. They ALL dont seem to want to comit to P1. If I force say Zone 1 As 'Used Zone' to 'Yes' and follow sequence as per manual, when I re check Zone 1 say may revert to...

Hi Having great difficulty programming this unit. Installation wired and has passed all installation tests. Sad really because I have done the difficult part! Installation I have wired all 8 zones. Zone 1 is the magnetic front door contacts. Zone 2 is wired to a PIR protecting Hallway...

Many thanks. I have now used reccomended latter method to inhibit three unused zones.

Hi Similar problem - currently installing my G4. I have not used all zones available. Can you advise how you solved this problem? Many thanks