Hi
Having great difficulty programming this unit. Installation wired and has passed all installation tests. Sad really because I have done the difficult part!
Installation
I have wired all 8 zones. Zone 1 is the magnetic front door contacts. Zone 2 is wired to a PIR protecting Hallway and door area. The LCD remote is located within the hallway and all three are withion 2 metres of each other. This represents entry/exit route for setting / resetting the G4.
As I set all 8 Zones to USED ('Yes' status) - seems sensible as all are USED in my installation, when I re check them after setting status, some zones seem to revert to 'No' - Unused? Similar problems occur when I set Zone 1 to Timed and Zone 2 (PIR) to inhibited.Again, status is not the same when I review the settings I made!! I have found the Engineers User Guide of little help to identify / resolve problem.
So, can you advise whether my zone assignmentis sensible given the installation described - do I need to use 'Omit Allow' function? and has anyone experienced similar programming difficulties/ resolved them. Incidentally I am setting Program 1 with a Timed Exit Mode.
Hope anyone can help. Have now spent over three hours scratching my head!
Mike
Having great difficulty programming this unit. Installation wired and has passed all installation tests. Sad really because I have done the difficult part!
Installation
I have wired all 8 zones. Zone 1 is the magnetic front door contacts. Zone 2 is wired to a PIR protecting Hallway and door area. The LCD remote is located within the hallway and all three are withion 2 metres of each other. This represents entry/exit route for setting / resetting the G4.
As I set all 8 Zones to USED ('Yes' status) - seems sensible as all are USED in my installation, when I re check them after setting status, some zones seem to revert to 'No' - Unused? Similar problems occur when I set Zone 1 to Timed and Zone 2 (PIR) to inhibited.Again, status is not the same when I review the settings I made!! I have found the Engineers User Guide of little help to identify / resolve problem.
So, can you advise whether my zone assignmentis sensible given the installation described - do I need to use 'Omit Allow' function? and has anyone experienced similar programming difficulties/ resolved them. Incidentally I am setting Program 1 with a Timed Exit Mode.
Hope anyone can help. Have now spent over three hours scratching my head!
Mike