Hi.
Close to completing a fireplace and in need of a brick cutting service.
Does anyone know of any brick cutting services in the North Manchester area? (Rochdale/Bury)
Please pm if know of any.
Hi there.
Looking for some advice, I've opened up a builders opening to it's original 1911 spec, due to the many different fireplaces over the years, the lintels installed by gas fitters have chewed up some of the column bricks, left side being the worst.
I've done a a fair bit myself...
We changed from a gravity system to an Intergas combi with a nest thermostat, the DHW at almost mains pressure was a real bonus.
Intergas support chap tweaked a few things for us after it was installed heating side is closer to 12kw now and the DHW reduced as default 55c is crazy hot.
Also the...
It's paired up with a Nest V3 using Opentherm - that may have something to do with it.
Therefore cycling through - or + gets you all manner of readings.
1. Press above the dot to reveal the spanner icon,
2. Press/hold spanner until water and radiator icons disappear and - + appear on the left
3. Press/hold spanner again, you can now cycle through the readings with - +, press above the dot to return to normal display.
This is how you can...
Hi all.
Is there a way to find the readings of the return temp via the touch panel?
I've looked in the manual, closest I've got is to press/hold of the spanner icon twice and cycle through the readings, but not sure which one is the return reading.
Any help much appreciated.
They all seem to have differing opinions regards to positioning of boiler, condensate. One even claimed I should flush the system after I fit the boiler :whistle:!!
I've asked two, one claimed I need an AM1 module, the other suggested a combi version and to get rid of the unit I bought.
Absolutely - the present system is antiquated and in dire need of a system flush. I have a Spirotech MB3 to be installed & TRV's.
I've not had any word on 'sealing the system' or adding a 'plate' from any of the heating chaps that have visited, at most 'fully pumped'. By 'plate' do you mean an...
Hi all.
I'm just looking for advice with regards to fitting a Veissmann 100 Heat only (19kw).
Present system is a twin channel gravity fed Baxi 401 setup, what I'd like to know is what layout plan would be best for this?
I'm interested in the S plan as it allows future expansion, I've read...
Hi All.
As of yesterday our Gainsborough shower (2000x energy) stays on the 'reduce temp' setting only as the led indicate. Fails to heat up any water at all, I tried all the settings low, medium, high. Even opened it up (isolated) can't seem to spot anything obvious.
The day before I...