Search results

I'm looking to get led spotlights installed, but I'm a little lost by the amount of spots lights required, my living room is roughly 4m X 5m and currently have a 13w light in the center of the room, my friends brother is a electrician and said I would need 8 lights, but if I installed that with...

Worcester green star cdi, hot water clock flash 026 there's nothing in the book or the programmers instrustions which is a dt10rf, it's only a year old and I see only one other person on the web seems to of had this problem, but no one as posted a answer

I was going to brick up a builders opening and fit a flueless fire In its place but am I right in thinking the builders opening still needs ventilation to prevent damp, if this is the case is there anyway around this as i can't have and vents near the flueless, many thanks all, and merry Christmas

evening all, what size adhasive spreader do you tend to use on ceramic tiles 400x150, also the window reveal is 230mm deep which means i will need to brick effect on this too?, i have seen bathrooms with brick effect around the room, and single tiles laid on the base of the window reveal and the...

Doing a gas check yesterday for a landlord which I just started doing little bits for, now the units above the work top were only 430mm high instead of the 460mm required, I've looked in my books and the in safe situation book but can't find what category it comes under as there's no scorching...

im a plumber/gas enginner, i also do a little bit of tiling and im not bad just slow, my problem is some friends bathroom i will be doing in the next few weeks needs tiling, the area is a 800x1400 shower tray, i,ve done full bathrooms before but this one as 300x600 tiles and they want brick...

been to look at a saunier duval, semia condens, with 21 flashing, the pressure is ok, when you call for hot water or heating the pump runs but have no power to the fan, i've made the pressure swicth and theres no attempt for it to try and light, will ring technical support in the morning, but...

Working on a cxi ultracom 24, my problem is the fault f9, I have 1.8 bar showing when I reset it, when the boiler starts up again Im sure I hear the divert vavle motor back and fore, but the fan does not run for the pre heat, after about a minute I get f9, had a faulty pump onces before and the...

Looking to get my self some insurance as this is something I need, unsure what the different is between public liability or just liability, or are they the same, many thanks

serviced a ideal mexico floor standing boiler today, it was ketteling when working sounded like the the heat exchanger was scaled, when i turned the temp down to stop the boiler working the pump stopped, read the manual and theres nothing about pump over run, does this boiler need it, tried...

hi i have been plumbing for 10 years and gas fitting for 5 i just renewed my gas and have deciced to go it alone, i was having some leaflets made which were double sided and were quite nice looking, not just plain. The price is 350.00 for 5000 from vistaprint does this sound about right for...

hi im a plumber/gas engineer and need a new fluke meter, they don't do the same as my old one so the bloke in the shop suggested the t5 600 but im unsure any advise would be great many thanks, would be testing thermistors and flame recifilecation from time to time,

hi im a trainee gas engineer, and came across a open flued floor standing boiler goin into a chimney with a liner, on the other side there was a gas fire with know liner also joining chimney, the enginner with me said this was fine but im unsure, have checked my books but couldn find any info :cry: