Search results

I was considering replacing the wood blade on my table saw with an Evolution RAGE Multi-Purpose Carbide-Tipped Blade, 255 mm, which will allow me to also cut metal and plastics. However my table runs at 4500rpm, and I believe the Evolution blades run slower. Can you see this being an issue?

At least, some of the pipe runs are probably 25 metres. I was wondering if it should be higher as some taps at the far end of the run have little pressure, even with low pressure taps.

Looking at the price of a new pump they seem over a grand....Is there a competitive replacement for the one I have? I have attached a photo if it helps (its probably obvious I am not into plumbing) Thanks[/IMG]

I had the filters checked about a year ago when I had a water softener melt down, so I presume they are ok.

Hi, I have had my shower pump in for close to 17 years, and think that the power is getting lower and lower over time. Do they need a service kit or replacement over time? The pump is a Stuart Turner Monsson 3.0bar twin Thanks

Do all the tap bits and pieces come in a box , a bit like a wall electrical socket or are the connections bare and get plastered back in. Also are there brackets to strengthen the installation? Thanks

I am contemplating fitting wall mounted taps with the pipework concealed in the wall. The walls in my bathroom are brick and plaster. How easy is it to fit these types of taps in a brick wall, or are wall mounted taps only suitable for plasterboard walls. Also are there different types of wall...

I get the feeling I probably did not word this right. I wish to replace an existing light switch which has the red cable connected to the top and the black at the bottom. When I install the dimmer switch which cable goes where. (I Have L1 and L2 connectors at the bottom of the dimmer and a...

:? I have a dimmer switch with L1 and L2 at the bottom of the switch and light bulb symbol (3) at the top. Would I be correct to wire L1 and the Lightbulb switch. (I do not have the wiring instructions)