Search results

Hi All, reckon it was 10-15 years ago that we had our cavity walls insulated. It was when British Gas had an offer on if it helps. Pretty sure it was the blown fibre. Anyway, in recent years we have been suffering from dampness around the top 6 inches or so of the outside walls. Its in several...

Hi All, we have just replaced an old Indesit gas hob with a dual fuel Stoves cooker. Have to admit that I am slightly dissappointed with the control sensitivity for the gas hob. Basically there is full flame when the controls reach about 50% travel. Its the same for all 4. After that there is no...

Hi All, applogies that variations of this question have already been asked, just not quite my setup. I'm replacing an old rotary room thermostat with a Honeywell DT90E. Old thermostat had a permanent live, switched live (by the thermostat), neutral and earth. The DT90e is a two wire...

Wife needs to paint small MDF letters, using a brush is a pain. Any suggestions?

Just doing a bit of reading around fitting a Salamander CT50+ shower pump and I notice that the AV couplings are 15mm but documentation talks about 22mm pipework. I know the Surrey flange on the cylinder is 22mm so where do I go down to 15mm? And what size is the feed from from the cold header...